Abstract:For reduced friction and enhanced anti-wear capability of 42CrMo alloy steel, herringbone textures with different features were fabricated on its surface using laser printing technology. The tribological properties of samples without and with different texture area occupancies (9.9, 13.3, 17.6, 22.1, 25.1, and 31.2%) were evaluated and compared using a MRTR multifunction friction and wear test machine. To understand the influence of area occupancy on tribological properties, in addition to the experimental study, the performance of the herringbone texture with different area occupancy rates was analyzed via fluid simulation using the ANSYS Fluent software. The simulation shows that the texture causes a hydrodynamic pressure effect on the oil lubricant. When the lubricating oil flows over or through the surface texture, positive and negative pressure regions are generated in the oil film. Negative pressure is generated in the divergent area, and positive pressure is generated in the convergence area. The results of the friction and wear tests show that samples with certain area occupancy textures have lower friction coefficients than smooth surfaces without texture, and when the area occupancy rate is too high, friction and wear cannot be reduced. Under the same operating conditions, the best tribological performance is achieved when the texture area occupancy rate is 17.6%, corresponding to a 26.6% reduction in the coefficient of friction. The appropriate surface texture morphology and area occupancy can lead to markedly improved tribological properties of the friction pair surface.

Investigation of Micro-wear and Micro-friction properties for bionic non-smooth concave components

Friction and wear behaviour of steel with bionic non-smooth surfaces during sliding

Study on Friction and Wear Performance of Bionic Coupling Surface Moving Pair of 45 Steel

The Friction And Wear Behavior Of Laser Textured Surfaces In Non-Conformal Contact Under Starved Lubrication

Experimental Research on Hydrophilic Property of Stainless Steel Bionic Non-smoothed Surface

Study of dry sliding friction and wear behavior of bionic surface of hardened steel

Influence of varying distribution distance and angle on fatigue wear resistance of 40Cr alloy steel with laser bionic texture

Simulation and Experimental Study on Tribological Properties of Herringbone Texture on 42CrMo Bearing Alloy Steel Surface

Experimental Study on the Wear Characteristics of Textured Joint Surfaces under Bionic Lubrication

Friction and wear properties of textured surface for bearing steel with mango-shaped micro geometries

Bionic Laser Surface Remelting for the Wear Performance after Thermal Fatigue of B2 Die Steel Based on Surface Stress Simulation

Effect of Composition on the Mechanical Properties and Wear Resistance of Low and Medium Carbon Steels with a Biomimetic Non-Smooth Surface Processed by Laser Remelting

Friction and wear characteristics modification via laser surface textured grooves

Surface Texturing for Low Friction Mechanical Components

Effect of Surface Roughness of Steel on Morphology of Laser-textured Micro-convex

Evaluation of tribological performance for laser textured surfaces with diverse wettabilities under water/oil lubrication environments

Investigation on the parameters optimization and sliding wear behaviors under starved lubrication of discrete laser surface hardened 25CrNi2MoV steel

Investigations on femtosecond laser modified micro-textured surface with anti-friction property on bearing steel GCr15

Additional Tribological Effect of Laser Surface Texturing and Diamond-Like Carbon Coating for Medium Carbon Steel at Near Room Temperature

Improvement of current-carrying tribological behaviour via laser surface texture

Investigation of the preparation and tribological behavior of a frictional interface covered with sinusoidal microchannels containing SnAgCu and Ti3SiC2