Abstract:The micro-texture is a relatively well-established method for improving the tribological performance of Co-Cr-Mo alloy. Currently, to fabricate the micro-textures on the alloy surface, laser micromachining technology is the commonly used method. However, the low fabrication quality (such as irregular protrusions inside and on the edges of the micro-textures) caused by laser ablation limits the numerous application of laser surface textures. Therefore, a novel method of combining nanosecond (ns) pulse laser texturing with ion beam etching was proposed to prepare the micro-textures on the surface of Co-Cr-Mo alloy. The tribological properties before and after ion beam etching were tested by ball-disk friction wear test for three different micro-texture morphologies (grooved micro-texture (G); hexagonal micro-texture (H); concentric micro-texture (C)), and the micro-topography, mechanical properties and wettability of the ion beam/laser textured Co-Cr-Mo alloy were also investigated. The results showed that the friction coefficient and wear amount of the specimen surface were reduced after ion beam etching, and the ion beam/laser textured sample with hexagonal micro-textures showed the best wear performance, with the average friction coefficient reduced by 11.9 % and the wear amount of polyether ether ketone balls reduced by 14.9 %. The worn surface of the ion beam etched samples was relatively smooth, and the adhesive wear was also reduced. This report established the friction reduction model of ion beam/laser textured alloy and revealed the friction reduction mechanism of ion beam etching, providing a new idea of fabricating high-quality micro-textures to enhance the wear performance of artificial hip joints.

Influence of varying distribution distance and angle on fatigue wear resistance of 40Cr alloy steel with laser bionic texture

Bionic Laser Surface Remelting for the Wear Performance after Thermal Fatigue of B2 Die Steel Based on Surface Stress Simulation

Anti-Wear Property of Laser Textured 42CrMo Steel Surface

Synergistic effect of surface sinusoidal textures and oxide layer on tribological properties of 40Cr alloy steel

Effect of ion beam etching on the tribological performance of laser textured Co-Cr-Mo alloy

Investigation of Micro-wear and Micro-friction properties for bionic non-smooth concave components

Optimization of Textured Parameters to Improve the Tribological Behavior of TC4-Based Bionic Coating Using RSM

Simulation and Experimental Study on Tribological Properties of Herringbone Texture on 42CrMo Bearing Alloy Steel Surface

Microstructure and wear behavior of arc-shaped 40CrNiMo steel after laser hardening

Study on Friction and Wear Performance of Bionic Coupling Surface Moving Pair of 45 Steel

Experimental Study on the Wear Characteristics of Textured Joint Surfaces under Bionic Lubrication

Effect of boron on the microstructural evolution and wear resistance of high-hardness Fe-based alloy coatings prepared by laser cladding

Surface condition driven fatigue performance of laser powder bed fusion H13 steel

Friction and wear properties of textured surface for bearing steel with mango-shaped micro geometries

A novel process for improving fatigue properties of TIG welded AZ31B mg alloy joints by laser bionic treatment

Effect of Nanosecond Laser Texturization on Tribological Behavior of AISI 321 Stainless Steel

Friction and wear behaviour of steel with bionic non-smooth surfaces during sliding

Structural Characteristics and Sliding Friction Properties of 40CrNiMo Steel after Broadband Laser Hardening

Improvement of current-carrying tribological behaviour via laser surface texture

Wear Resistance of Different Bionic Structure Manufactured by Laser Cladding on Ti6Al4V

Combined Effect of a Laser Cladded Coating and Surface Texture on Tribological Performance Under Dry Sliding and Starved Lubrication