Abstract:A series of MnCo/Cu-ZSM-5 (MnCo/Cu-Z) catalysts with different Mn/Co ratios for the selective catalytic reduction (SCR) of NO with NH3 were prepared by the combination of ion exchange and impregnation. The physicochemical properties of the catalysts were investigated by N2 adsorption/desorption, X-ray diffraction (XRD), temperature-programmed reduction with hydrogen (H2-TPR), X-ray photoelectron spectroscopy (XPS), and temperature-programmed desorption of NOx (NOx-TPD) and NH3 (NH3-TPD), and the diffuse reflectance infrared Fourier transform (DRIFT) technique was employed for the detection of intermediate species and the study of the mechanism. The introduction of Mn and Co boosts the catalytic activity of the Cu-Z catalyst at a temperature below 200 °C, and the optimum activity was obtained over the Mn1Co2/Cu-Z catalyst. The enrichment of the high-valent metal ion on the catalyst surface and the improvement in the reducibility of metal oxide are responsible for the elevation in the catalytic activity of MnCo/Cu-Z. The bridged and bidentate modes are the prevailing nitrate species on the Cu-Z and MnCo/Z catalysts, respectively, and both of them were detected over the MnCo/Cu-Z catalyst. Furthermore, the DRIFT spectroscopy (DRIFTS) results indicate that, at 150 °C, the bridged nitrate can react with the adsorbed ammonia species, but the bidentate nitrate fails to do. The SCR reaction over the Cu-Z catalyst follows the Eley–Rideal and Langmuir–Hinshelwood mechanisms simultaneously at 150 °C, whereas an overwhelming dominance of the Eley–Rideal mechanism is identified for the MnCo/Z catalyst. As to the SCR mechanism on the MnCo/Cu-Z catalyst, it combines the features of Cu/Z and Mn1Co2/Z.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.1c01172?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.1c01172</a>.Physical properties of catalysts; peak positions and assignments in the DRIFT Spectra; effects of H2O on NOx conversion; effects of H2O on the stability of catalysts; EDS element mapping of catalysts; and relative amount of surface acid sites (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.1c01172/suppl_file/cs1c01172_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Catalytic reduction of NO on the catalysts supported on activated carbon fibers. I. Copper-series catalysts

The Role of Surface Properties of Activated Carbon in the Catalytic Reduction of NO by Carbon

Effect of Pretreatment Method of Activated Carbon on the Catalytic Reduction of NO by Carbon over CuO

Selective catalytic reduction of NO with NH3 over CuOX-carbonaceous materials

Nitrogen-Doped Pitch-Based Activated Carbon Fibers with Multi-Dimensional Metal Nanoparticle Distribution for the Effective Removal of NO

Activation of Fast Selective Catalytic Reduction of NO by NH3 at Low Temperature over TiO2 Modified CuOX-CeOX Composites

Simultaneous removal of NO x and SO 2 by low-temperature selective catalytic reduction over modified activated carbon catalysts

Catalytic Oxidation of NO at Room Temperature by Pitch-Based Activated Carbon Fibers

Experimental Investigation into the Denitrification Performance of a CuO/AC Catalyst Used for NO Reduction with Ammonia

Micro-structured Cu-ZSM-5 catalyst on aluminum microfibers for selective catalytic reduction of NO by ammonia

Catalytic Reduction of NO with NH 3 over V 2 O 5 -MnO X /TiO 2 -Carbon Nanotube Composites

Preparation of Pitch-based Activated Carbon Fibers and Their Catalytic Oxidation Performance for NO

Effect of Preparation Condition on NO Removal Activity over Activated Carbon Honeycomb Supported MnOx Catalyst

Selective Catalytic Reduction Of Nox With Nh3 At Low Temperatures Over Metal Oxide Supported On Ac-C Cellular Monoliths

Highly active and stable Cu Fe /AC-H catalysts with CuFe2O4 for NO reduction by CO in the presence of H2O and SO2 under regeneration gas

Insight into the promotion mechanism of activated carbon on the monolithic honeycomb red mud catalyst for selective catalytic reduction of NOx

MnOx–CeO2/Activated Carbon Honeycomb Catalyst for Selective Catalytic Reduction of NO with NH3 at Low Temperatures

Low temperature selective catalytic reduction of NOx by NH3 over Cu modified V2O5/TiO2–carbon nanotube catalyst

Selective catalytic reduction of NOx with NH3 by monolithic catalyst MnOx/AC/C under low temperature in the presence of excess O2

Cu-ZSM-5 Catalyst Impregnated with Mn–Co Oxide for the Selected Catalytic Reduction of NO: Physicochemical Property–Catalytic Activity Relationship and In Situ DRIFTS Study for the Reaction Mechanism

Accelerating Electrocatalytic Nitrate Reduction to Ammonia Via Weakening of Intermediate Adsorption on Cu-Based Catalyst