Abstract:With the advancement of semiconductor manufacturing technology, thin film structures were widely used in MEMS devices. These films played critical roles in providing support, reinforcement, and insulation in MEMS devices. However, due to their microscopic dimensions, the sensitivity of their parameters and performance to thermal stress increased significantly. In this study, a Pirani gauge sample with a multilayer thin film structure was designed and fabricated. Based on this sample, finite element modeling analysis and thermal stress experiments were conducted. The finite element modeling analysis employed a combination of steady-state and transient methods to simulate the deformation and stress distribution of the device at room temperature (25 °C), low temperature (−55 °C), and high temperature (125 °C). The thermal stress test involved placing the sample in a temperature cycling chamber for temperature cycling tests. After the tests, the resonant frequency and surface deformation of the device were measured to quantitatively evaluate the impact of thermal stress on the deformation and resonant frequency parameters of the device. After the experiments, it was found that the clamped-end beams made of Pt were a stress concentration area. Additionally, the repetitive thermal load caused the cantilever beam to move cyclically in the Z direction. This movement altered the deformation of the film and the resonant frequency. The suspended film exhibited concavity, and the overall trend of the resonant frequency was downward. Over time, this could even lead to the fracture of the clamped-end beams. The variation of mechanical parameters derived from finite element simulations and experiments provided an important reference value for device design improvement and played a crucial role in enhancing the reliability of thin film devices.

In Situ Test Structures for the Thermal Expansion Coefficient and Residual Stress of Polysilicon Thin Films

A Novel Approach to Study Patterned Thin Film Local Stress for Microelectronics Application

Evaluation of Mechanical Properties and Strain Criterion for Realibility Design of Micromachined Polysilicon Thin Films

Micromechanical Characterization of Polysilicon Films through On-Chip Tests

OS5-2-3 an In-Situ Micro-Tension Setup and Its Application

Study of Local Stress Using Stress-Absorbing Si Diaphragm

Determining the thermal expansion coefficient of thin films for a CMOS MEMS process using test cantilevers

Improvement Of Thin Film Tensile Testing Technology Using Process Integrated Specimen And Considering Its Out-Of-Plane Deformation

Microstructures for Characterization of Seebeck Coefficient of Doped Polysilicon Films

In Situ and Real-Time Tensile Testing of Thin Films Using Double-Field-of-view Electronic Speckle Pattern Interferometry

Scale Dependence of Tensile Strength of Micromachined Polysilicon MEMS Structures Due to Microstructural and Dimensional Constraints

A new in situ residual stress measurement method for a MEMS thin fixed-fixed beam structure

Mechanical Characterization of Polysilicon MEMS: A Hybrid TMCMC/POD-Kriging Approach

Experimental and Theoretical Study of Young Modulus in Micromachined Polysilicon Films

Variation of MEMS Thin Film Device Parameters under the Influence of Thermal Stresses

A Method of Measuring Young's Modulus and Residual Stress in Typical MEMS Structures Using a Surface Profilometer

Ultra-sensitive, Highly Reproducible Film Stress Characterization Using Flexible Suspended Thin Silicon Plates and Local Curvature Measurements

Measurement and Isolation of Thermal Stress in Silicon-On-Glass MEMS Structures

Study of techniques for measuring residual stress in micromachined films

Thermal Stresses of Tsvs with Silicon Post Conductors and Polymer Insulators

An Apparatus for Measuring Mechanical Properties of Microstructures in Tensile Mode