Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

A Multi-Mode Blocker-Tolerant GNSS Receiver with CT Sigma-Delta ADC in 65nm CMOS

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

An Asymmetric Dual-Channel Reconfigurable Receiver For Gnss In 180nm Cmos

A 180nm fully-integrated dual-channel reconfigurable receiver for GNSS interoperations

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A High-Linearity 7–9-Ghz Receiver Front End with Strength-Oriented Nonlinearity Cancellation

A Dual-Channel GPS/Compass/Galileo/GLONASS Reconfigurable GNSS Receiver in 65nm CMOS

Low-Power High-Linearity Area-Efficient Multi-Mode Gnss Rf Receiver in 40nm Cmos

A Dual-Channel Compass/GPS/GLONASS/Galileo Reconfigurable GNSS Receiver in 65 Nm CMOS with On-Chip I/Q Calibration.

A 0.4-6 GHz Blocker-Tolerant Receiver in 65 Nm CMOS with Bandwidth-Extended Technologies for Future V2X Applications

A 2-Mw 50-Db DR Wideband Hybrid AGC for a GNSS Receiver in 65 Nm CMOS

Self-tuned SAW-less GNSS receiver front end with blocker filtering and gain-irrelevant DC offset cancellation

A Fully Integrated Low-Power Multi-Mode RF Receiver for BDS-3/GPS

Reconfigurable Dual-Channel Multiband RF Receiver for GPS/Galileo/BD-2 Systems

A 5/20Mhz-Bw 4.2/8.1mw CT QBP &#x03a3;&#x0394; Modulator with Digital I/Q Calibration for GNSS Receivers

A 54.4-Mw 4th-Order Quadrature Bandpass Ct Sigma Delta Modulator With 33-Mhz Bw And 10-Bit Enob For A Gnss Receiver

A 54.4-mW 4<sup>th</sup>-order quadrature bandpass CT ΣΔ modulator with 33-MHz BW and 10-bit ENOB for a GNSS receiver