Abstract:An interference-robust reconfigurable receiver in 65-nm CMOS is presented. The front end is split into a low-band (LB) RF path (0.1-1.5 GHz) and a high-band (HB) RF path (1-5 GHz). By utilizing a harmonic recombination technique, the LB path could reject the third/fifth-order harmonic interferences. A tunable narrowband dual-feedback commongate low-noise amplifier (LNA) with LC resonant load provides second-order bandpass filtering to reject the harmonic interferences in the HB path. The RF high-Q bandpass filtering based on the voltage-mode passive mixer and the current-mode low-pass filter in the analog baseband improves the receiver's resilience to out-of-band interferences. A novel power-detectionbased automatic frequency calibration technique is proposed to calibrate the operating frequency of the LNA in the HB path and overcome the effects of process, voltage, and temperature variations. The presented receiver has been implemented in a 65-nm CMOS and consumes 20-76-mW power from 1.2-V power supplies, with a core die area of 5 mm(2). The measured results show that the receiver can tolerate -5-dBm interference with 16-dB noise figure (NF) and achieve 95-105-dB maximum conversion gain and 1.7-8-dB NF over 0.1-5 GHz. It also achieves an average harmonic rejection (HR3)/HR5 of 61/68dB, +7.1/+14.4 dBm in-band/out-of-band input third-order intercept point (OB-IIP3), +71.2-dBm OB-IIP2, and 58.1-dB-image rejection, after the digitally assisted calibrations. The system-level measurements show that the presented receiver achieves 2.1% error vector magnitude (EVM) for 850-MHz Global System for Mobile Communication signals and 5% EVM for band 42 time division duplexing-local thermal equilibrium (LTE) signals, respectively.

An Asymmetric Dual-Channel Reconfigurable Receiver For Gnss In 180nm Cmos

A 180nm fully-integrated dual-channel reconfigurable receiver for GNSS interoperations

A Dual-Channel GPS/Compass/Galileo/GLONASS Reconfigurable GNSS Receiver in 65nm CMOS

A Dual-Channel Compass/GPS/GLONASS/Galileo Reconfigurable GNSS Receiver in 65 Nm CMOS with On-Chip I/Q Calibration.

Reconfigurable Dual-Channel Multiband RF Receiver for GPS/Galileo/BD-2 Systems

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

An area-efficient dual-channel RF receiver for GPS-L1/Galileo-E1/Compass-B1

Low-Power High-Linearity Area-Efficient Multi-Mode Gnss Rf Receiver in 40nm Cmos

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

A High-Linearity 7–9-Ghz Receiver Front End with Strength-Oriented Nonlinearity Cancellation

A Multi-Mode Blocker-Tolerant GNSS Receiver with CT Sigma-Delta ADC in 65nm CMOS

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A Tri-Mode Reconfigurable Receiver for GNSS/NB-IoT/BLE with 68-Db HR3 and 60-Db IMRR in 28-Nm CMOS

A low power triple-mode parallel-processing CMOS receiver for BD-II/GPS/Galileo joint navigation applications

An Interference-Robust Reconfigurable Receiver with Automatic Frequency-Calibrated LNA in 65-Nm CMOS

A Multi-Mode Reconfigurable Analog Baseband With I/Q Calibration For Gnss Receivers

Four-channel broadband compact multi-antenna GNSS downconverter for high-reliability navigation

A Fully Integrated Low-Power Multi-Mode RF Receiver for BDS-3/GPS