Abstract:Current dual-constellation GNSS navigation receiver can not fully satisfies the development of navigation industry. The architecture of current Compass and GPS dual-constellation navigation receiver is usually built upon FPGA and float-point DSP. Compared with fix-point DSP and FPGA, float-point DSP works slow and costs much, and it is also difficult to integrate float-point DSP into ASIC or ASSP. So in this paper, we discuss the optimized algorithm and the new implementation that integrate all parts of navigation receiver on one FPGA or ASIC.Our revised algorithm of navigation receiver is introduced first, mainly including acquisition and tracking mechanism. For acquisition module, we divide the whole acquisition process into three units: noise threshold detection, pre-acquisition, acquisition verification. For tracking module, with the help of accurate fix-point simulation, float-point variables are converted to fix-point ones, and rescaling is applied during all process to assure precision.Algorithm only makes sense when it combines with implementation, and the quality of algorithm also should be tested by application. So we also introduce the implementation of navigation receiver baseband algorithm on FPGA platform, including platform architecture, module division, work flow, and some optimization mechanics including resource sharing, process combination and etc. And we simply introduce the measure result and the application of dual-constellation navigation receiver baseband processor.And viterbi decoder for navigation receiver is also discussed. This paper brings forward a revised mechanism of viterbi decoder especially for navigation receiver. We borrow the soft output viterbi algorithm, but do not adopt the algebra ring method, and put forward revised viterbi mechanics. And the optimization is also on shorten-decoding, survival-path combination, butterfly calculation of ACS unit.

A low power triple-mode parallel-processing CMOS receiver for BD-II/GPS/Galileo joint navigation applications

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

An area-efficient dual-channel RF receiver for GPS-L1/Galileo-E1/Compass-B1

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

Reconfigurable Dual-Channel Multiband RF Receiver for GPS/Galileo/BD-2 Systems

Low-Power High-Linearity Area-Efficient Multi-Mode Gnss Rf Receiver in 40nm Cmos

A Dual-Channel GPS/Compass/Galileo/GLONASS Reconfigurable GNSS Receiver in 65nm CMOS

A 180nm fully-integrated dual-channel reconfigurable receiver for GNSS interoperations

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A Fully Integrated Low-Power Multi-Mode RF Receiver for BDS-3/GPS

An Asymmetric Dual-Channel Reconfigurable Receiver For Gnss In 180nm Cmos

A CMOS Low Power K-band FMCW Radar Transceiver Front-End for AIOT Application

A Dual-Channel Compass/GPS/GLONASS/Galileo Reconfigurable GNSS Receiver in 65 Nm CMOS with On-Chip I/Q Calibration.

Design of triple-band CMOS GPS receiver RF front-end

A Multi-Mode Blocker-Tolerant GNSS Receiver with CT Sigma-Delta ADC in 65nm CMOS

A GPS/Galileo Dual-module Dual-band Receiver RF Front-end Design

A 10-B Fourth-Order Quadrature Bandpass Continuous-Time $\sigma \delta $ Modulator with 33-Mhz Bandwidth for a Dual-Channel GNSS Receiver

Design and Implementation of a Real‐time Software Receiver for BDS‐3 Signals

An Optimal Joint Processing Method for BDS B1I and B1C Signals

The Optimization of Algorithm and Implementation for Dual-Constellation Navigation Receiver

A Tri-Mode Reconfigurable Receiver for GNSS/NB-IoT/BLE with 68-Db HR3 and 60-Db IMRR in 28-Nm CMOS