Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

Design of triple-band CMOS GPS receiver RF front-end

A High-Linearity 7–9-Ghz Receiver Front End with Strength-Oriented Nonlinearity Cancellation

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

Low-Power High-Linearity Area-Efficient Multi-Mode Gnss Rf Receiver in 40nm Cmos

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

A low power triple-mode parallel-processing CMOS receiver for BD-II/GPS/Galileo joint navigation applications

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

An area-efficient dual-channel RF receiver for GPS-L1/Galileo-E1/Compass-B1

Reconfigurable Dual-Channel Multiband RF Receiver for GPS/Galileo/BD-2 Systems

A Fully Integrated Low-Power Multi-Mode RF Receiver for BDS-3/GPS

A Dual-Channel GPS/Compass/Galileo/GLONASS Reconfigurable GNSS Receiver in 65nm CMOS

A GPS/Galileo Dual-module Dual-band Receiver RF Front-end Design

A 180nm fully-integrated dual-channel reconfigurable receiver for GNSS interoperations

An Asymmetric Dual-Channel Reconfigurable Receiver For Gnss In 180nm Cmos

A low-noise amplifier using subthreshold operation for GPS-L1 RF receiver

A Dual-Channel Compass/GPS/GLONASS/Galileo Reconfigurable GNSS Receiver in 65 Nm CMOS with On-Chip I/Q Calibration.

RF Front-End Band-Pass Filters for GPS Receiver

Single Feed Stacked Patch Circular Polarized Antenna for Triple Band GPS Receivers