Abstract:This letter presents a compact low temperature co-fired ceramic (LTCC) receiver front-end module integrating 9 building blocks.The receiver is a twice-frequency-conversion front-end module with image rejection, works at X-band, consists of an X-band embedded image rejection band-pass filter (BPF), an Lband multilayer image rejection quasi-ellipitc BPF, two monolithic microwave integrated circuit (MMIC) low noise amplifiers (LNAs), two intermediate frequency (IF) amplifiers, two mixers, a IF BPF, and some lumped passive components.All MMICs are mounted into premaking cavities in the three layers LTCC substrate of the top surface, and the interconnection between MMICs and surface microstrip-line is established by bond wires.A multilayer five-pole Chebyshev interdigital BPF is developed as the first image rejection filter, and a four-pole quasi-elliptic BPF composed of stepped-impedance hairpin resonator and miniaturized hairpin resonators that can be coupled through the apertures on the common ground plane is proposed for as the second image rejection filter.The developed X-band receiver front-end module is fabricated using twenty layers LTCC dielectric substrate, which has a compact size of 30 × 20 × 20 mm 3 (including the metal cavity).The measured receiver gain and noise figure are more than 32 dB and less than 4 dB, respectively.The first and second image rejection is better than 28 dB and 40 dB, respectively.Compared with conventional receiver front-end module using hybrid microwave integrated circuit (HMIC) technology, the proposed receiver module not only has compact size, but also has good performance.

A CMOS Analog Integrated Front End for L Band DAB Receiver

A Monolithic CMOS L Band DAB Receiver

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A CMOS Low Power K-band FMCW Radar Transceiver Front-End for AIOT Application

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 54-67-ghz Low-Power Highly-Integrated Transceiver in 65-Nm CMOS for FMCW Radar Applications

A COMPACT X-BAND RECEIVER FRONT-END MODULE BASED ON LOW TEMPERATURE CO-FIRED CERAMIC TECHNOLOGY

A 0.13&#x03bc;m CMOS UWB Receiver Front-End Using Passive Mixer

A RF Front-End for Digital Audio Broadcasting

0.6–3-Ghz Wideband Receiver RF Front-End with a Feedforward Noise and Distortion Cancellation Resistive-Feedback LNA

A Fully Integrated K-Band Dual Down-Conversion Receiver for Radar Applications in 90 Nm CMOS.

A Low Power 3–5 GHz CMOS UWB Receiver Front-End

An Integrated K-Band Receiving Front-End Module for Satellite Communication

A D-Band Joint Radar-Communication CMOS Transceiver

A high-linearity receiver RF front-end with a high-performance 25%-duty-cycle LO generator for WCDMA/GSM applications

An RF Front-End for a Fully Integrated CMOS DTV Tuner