Abstract:This article presents a reconfigurable phased-array receiver (RX) front-end supporting multiple fifth-generation (5G) new radio (NR) frequency range 2 bands at 26/28/39 GHz. A reconfigurable frequency downconverter (RFDC) with two operating modes is proposed to cover both K -and Ka -bands. Distinct from conventional wideband or multi-band structures, the proposed one does not need wide/multiple local-oscillator (LO) or intermediate-frequency (IF) bands. Cooperating with an appropriate LO-and IF-frequency scheme, the reconfigurable architecture moves image interferences out of a passband of RF channels in both the modes, and thus an excellent image rejection is achieved. A compact and fast built-in calibration (BIC) circuit, which is based on an adjacent-channel envelope comparison technique, is also developed to cope with potential phase and gain errors in each RF channel. The phased-array RX is demonstrated using a 65-nm CMOS technology. Measurement results show that the RX successfully covers both 24-30-GHz and 36-40-GHz bands, while only requiring an LO range of 9.5-12.5 GHz with 5-GHz IF. The tested gains, noise figure (NF), and input 1-dB compression point are 16.2/16.9 dB, 5.9/6.2 dB, and - 30.7/ -31.4 dBm at 26/28 GHz when it functions in a differential mode, while the corresponding results are measured as 15.3 dB, 6.6 dB, and - 32.8 dBm at 39 GHz in a common mode. Tested image-rejection ratios (IRRs) are 43 dB in both the operating modes. The BIC circuits' functionality is also tested. It reduces root-mean-square (rms) gain and phase errors of the RX by 0.12-0.28 dB and 2.3(degrees) - 4.5(degrees) , respectively. Therefore, the RX's tested beamforming performance is greatly improved, compared with the one without calibration.

A Tri-Mode Reconfigurable Receiver for GNSS/NB-IoT/BLE with 68-Db HR3 and 60-Db IMRR in 28-Nm CMOS

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A 180nm fully-integrated dual-channel reconfigurable receiver for GNSS interoperations

A High-Linearity 7–9-Ghz Receiver Front End with Strength-Oriented Nonlinearity Cancellation

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

An Asymmetric Dual-Channel Reconfigurable Receiver For Gnss In 180nm Cmos

A 60–90 GHz Mixer-First Receiver with Adaptive Temperature-Compensation Technique

A Dual-Channel Compass/GPS/GLONASS/Galileo Reconfigurable GNSS Receiver in 65 Nm CMOS with On-Chip I/Q Calibration.

Reconfigurable Dual-Channel Multiband RF Receiver for GPS/Galileo/BD-2 Systems

A Dual-Channel GPS/Compass/Galileo/GLONASS Reconfigurable GNSS Receiver in 65nm CMOS

Low-Power High-Linearity Area-Efficient Multi-Mode Gnss Rf Receiver in 40nm Cmos

An Interference-Robust Reconfigurable Receiver with Automatic Frequency-Calibrated LNA in 65-Nm CMOS

A Multi-Mode Reconfigurable Analog Baseband With I/Q Calibration For Gnss Receivers

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

A 0.1–5.0 GHz Flexible SDR Receiver with Digitally Assisted Calibration in 65 Nm CMOS

A 26/28/39-Ghz Reconfigurable Phased-Array Receiver Front-End with Built-In Calibration Technique for 5G New Radio

A 0.1 Similar To 4ghz Receiver And 0.1 Similar To 6ghz Transmitter With Reconfigurable 10 Similar To 100mhz Signal Bandwidth In 65nm Cmos

A Multi-Mode Blocker-Tolerant GNSS Receiver with CT Sigma-Delta ADC in 65nm CMOS

A Fully Integrated Low-Power Multi-Mode RF Receiver for BDS-3/GPS

A 0.12mm2 K/Ka Band RX Front-end in 40-Nm CMOS with Inductor-Less LO Generators