Abstract:This paper presents a 0.2 similar to 3.8-GHz in-band (IB) full-duplex (FD) mixer-first receiver based on a vector self-interference (SI) canceller. To ensure the wideband orthogonality of the reconstructed SI signal while minimizing the noise figure (NF) degradation in FD mode, a low insertion loss two-stage polyphase filter (PPF) with a lacking resistance and capacitance (LRC) structure is used in the SI canceller. A 6-bits passive capacitor digital to analog converter (C-DAC) attenuator not only realizes the high-precision amplitude adjustment of the reconstructed SI signal but also avoids the linearity limitation of the back-end modules of the canceller and reduces the noise contribution of the front-end modules at the canceller output. A four-phase mixer-first receiver with enhanced out-of-band (OOB) interference suppression is designed to provide sufficient linearity to reduce the SI-induced nonlinear distortion. As a proof of concept, a prototype FD receiver is fabricated in CMOS 65 nm technology and measured in chip-on-board (COB) package. Measurement results show that it can operate in the frequency range of 0.2 similar to 3.8-GHz with more than 25 dB SIC amount for 10 MHz bandwidth (BW) 64-QAM modulated signals in fixed (30 dB) channel attenuation test setup. The receiver achieves OOB input-referred third-order intercept point (OOB-IIP3) of +24 dBm and OOB input-referred second-order intercept point (OOB-IIP2) of +82 dBm at 1-GHz local oscillator (LO) frequency. In FD mode, the NF degradation is <= 1.5 dB. The effective IB-IIP3 and effective IB-IIP2 are enhanced by 15 dB and 28 dB, respectively. The power consumption of entire FD receiver including the SI canceller is less than 44 mW. The active chip area is 0.55 mm(2).

Self-tuned SAW-less GNSS receiver front end with blocker filtering and gain-irrelevant DC offset cancellation

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A High-Linearity 7–9-Ghz Receiver Front End with Strength-Oriented Nonlinearity Cancellation

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A Multi-Mode Blocker-Tolerant GNSS Receiver with CT Sigma-Delta ADC in 65nm CMOS

Saw-Less Gnss Front-End Amplifier With 80.4-Db Gsm Blocker Suppression Using Cmos Directional Coupler Notch Filter

A 2-Mw 50-Db DR Wideband Hybrid AGC for a GNSS Receiver in 65 Nm CMOS

An Asymmetric Dual-Channel Reconfigurable Receiver For Gnss In 180nm Cmos

A 0.07–3 GHz Wideband Front-End for SDR Receiver with 2.3 Db NF and 12 Dbm IIP<sub>3</sub> in 65 Nm CMOS

A 0.1–5.0 GHz Flexible SDR Receiver with Digitally Assisted Calibration in 65 Nm CMOS

A 253- $\mu $ W 2.4-Ghz SAW-Less Mixer-First Uncertain-IF Receiver with Blocker Tolerant for Long-Distance Ultralow-Power IoT

A 0.2~3.8-Ghz Full-Duplex Receiver with More Than 25 Db Self-Interference Cancellation Using a C-DAC-Based Vector Canceller.

Four-channel broadband compact multi-antenna GNSS downconverter for high-reliability navigation

A 52-to-73GHz Tri-Coupled Transformer Based Noise Self-Canceling and Gm-Boosting LNA with 3.78dB NF and 22.4dB Gain in 40nm CMOS

ADS optimization design of GPS RF front-end circuit with auto gain control

A low power single ended input differential output low noise amplifier for L1/L2 band

A 180nm fully-integrated dual-channel reconfigurable receiver for GNSS interoperations

A 0.2~3.8-GHz Full-Duplex Receiver With More Than 25 dB Self-Interference Cancellation Using a C-DAC-Based Vector Canceller

A Low-Power 2.4-Ghz Receiver Front-End with a Complementary Series Feedback LNA and a Current-Reused Passive Down-Converter Based on Gm-Boosted TIA for WSN Applications.