Abstract:An interference-robust reconfigurable receiver in 65-nm CMOS is presented. The front end is split into a low-band (LB) RF path (0.1-1.5 GHz) and a high-band (HB) RF path (1-5 GHz). By utilizing a harmonic recombination technique, the LB path could reject the third/fifth-order harmonic interferences. A tunable narrowband dual-feedback commongate low-noise amplifier (LNA) with LC resonant load provides second-order bandpass filtering to reject the harmonic interferences in the HB path. The RF high-Q bandpass filtering based on the voltage-mode passive mixer and the current-mode low-pass filter in the analog baseband improves the receiver's resilience to out-of-band interferences. A novel power-detectionbased automatic frequency calibration technique is proposed to calibrate the operating frequency of the LNA in the HB path and overcome the effects of process, voltage, and temperature variations. The presented receiver has been implemented in a 65-nm CMOS and consumes 20-76-mW power from 1.2-V power supplies, with a core die area of 5 mm(2). The measured results show that the receiver can tolerate -5-dBm interference with 16-dB noise figure (NF) and achieve 95-105-dB maximum conversion gain and 1.7-8-dB NF over 0.1-5 GHz. It also achieves an average harmonic rejection (HR3)/HR5 of 61/68dB, +7.1/+14.4 dBm in-band/out-of-band input third-order intercept point (OB-IIP3), +71.2-dBm OB-IIP2, and 58.1-dB-image rejection, after the digitally assisted calibrations. The system-level measurements show that the presented receiver achieves 2.1% error vector magnitude (EVM) for 850-MHz Global System for Mobile Communication signals and 5% EVM for band 42 time division duplexing-local thermal equilibrium (LTE) signals, respectively.

A 0.4-6 GHz Blocker-Tolerant Receiver in 65 Nm CMOS with Bandwidth-Extended Technologies for Future V2X Applications

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

A 0.1 Similar To 4ghz Receiver And 0.1 Similar To 6ghz Transmitter With Reconfigurable 10 Similar To 100mhz Signal Bandwidth In 65nm Cmos

A 0.1–4 GHz SDR receiver with reconfigurable 10–100 MHz signal bandwidth in 65 nm CMOS

A Multi-Mode Blocker-Tolerant GNSS Receiver with CT Sigma-Delta ADC in 65nm CMOS

A 26.6mw 1gb/s Dual-Antenna Wideband Receiver with Auto Beam Steering for Secure Proximity Communications

An Interference-Robust Reconfigurable Receiver with Automatic Frequency-Calibrated LNA in 65-Nm CMOS

A 253- $\mu $ W 2.4-Ghz SAW-Less Mixer-First Uncertain-IF Receiver with Blocker Tolerant for Long-Distance Ultralow-Power IoT

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

A -10.1Dbm IIP3, 0.3-40Ghz Receiver Using Hybrid-Path Band-Selection with Reduced LO Coverage Bandwidth Supporting 480mb/s 4096-QAM and 7.2gb/s 64-QAM Modulation

A 0.1–5ghz Flexible SDR Receiver in 65nm CMOS

A Baseband-Noise-Cancelling Mixer-First CMOS Receiver Frontend Attaining 220 MHz IF Bandwidth With Positive-Capacitive-Feedback TIA

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

A 180nm CMOS wireless transceiver by utilizing guard band for narrowband IoT applications