Influences of Preparation Methods on Bipolar Switching Properties in Copper Nitride Films

Qianfei Zhou,Qian Lu,Yongning Zhou,Yin Yang,Xiaoqin Du,Xin Zhang,Xiaojing Wu

DOI: https://doi.org/10.1016/j.surfcoat.2012.08.028

2013-01-01

Abstract:Copper nitride (CuxN) films were prepared by plasma immersion ion implantation (PIII) as well as by reactive magnetron sputtering (RMS). Based on X-ray diffraction (XRD) analysis, a semiconductive phase Cu3N could be found in the films prepared by both methods. On the other hand, a copper-rich conductive phase Cu4N was observed only in the film prepared by PIII, in which gradually distributed nitrogen could be identified by secondary ion mass spectroscopy (SIMS) analysis. The resistive switching properties have been studied after depositing Ni as the top electrode. The Ni/CuxN/Cu memory devices prepared by PIII method showed a forming-free characteristic with a low operation voltage of ±0.2V, excellent DC and AC endurance performances at least longer than 600 times and 105 times with resistance window of 50 and 12 respectively. On the contrary, the resistive switching behavior for the device prepared by RMS needed a forming process and was unstable. The excellent performances in PIII prepared films were attributed to the coexistence of metallic Cu4N phase and gradually decreased nitrogen concentration. It was supposed that the Cu atoms bridge the small gaps between the bottom and top electrodes and form the conducting filaments.