Abstract:A MEMS thin-film getter–heater unit has been previously proposed for the vacuum packaging of a Micro-Electro-Mechanical System (MEMS) device, where the floating structure (FS) design is found to be obviously more power-efficient than the solid structure (SS) one by heat transfer capacity simulation. However, the mechanical strength of the FS is weaker than the SS by nature. For high temperature usage, the unit structure must be optimized in order to avoid fracture of the cantilever beam or film delamination due to strong excessive stress caused by heating. In this paper, COMSOL is used to simulate the stress and deformation of the MEMS thin-film getter–heater unit with the cantilever structure. By comparing various cantilever structures, it is found that a model with a symmetrically-shaped heater and edge–center-located cantilever model (II-ECLC model) is the most suitable. In this model, even when the structure is heated to about 600 °C, the maximum stress of the cantilever beam is only 455 MPa, much lower than the tensile strength of silicon nitride (Si3N4, 12 GPa), and the maximum deformation displacement is about 200 μm. Meanwhile, the interfacial stress between the getter and the insulating layer is 44 MPa, sufficiently lower than the adhesion strength between silicon nitride film and titanium film (400–1850 MPa). It is further found that both the stress of the cantilever structure and the interfacial stress between the getter and the insulating layer beneath increase linearly with temperature; and the deformation of the cantilever structure is proportional to its stress. This work gives guidance on the design of MEMS devices with cantilever structures and works in high temperature situations.

Simulation analysis of thermal-actuated PDMS film microvalve

Analysis of the Flow Characteristics of Diffuser/Nozzle Based on MEMS

Comparing research on two different numerical models of electrostatically actuated valveless micropump

Optimization design of actuator in silicon micro-valve for large flow applications

Preparation of thermoswitchable micro capillary force valves inside polydimethylsiloxane microfluidic channels

Fabrication of Micro Pneumatic Valves with Double-Layer Elastic Poly(dimethylsiloxane) Membranes in Rigid Poly(methyl Methacrylate) Microfluidic Chips

Reasearch and fabrication of integrated pneumatic microvalves in polymer microfluidic chip

On-chip integrated multi-thermo-actuated microvalves of poly(N-isopropylacrylamide) for microflow injection analysis

Preparation of Normally Open Microvalves with Fluorinated Ethylene Propylene Membrane and Poly(methyl Methacrylate) Substrates

Analysis and experimentation of novel asymmetric photo-thermal micro-actuator

A New Torque-Actuated Valve For Pdms Microfluidic Chip

Fluid Dynamics Investigation on the Body Structure Inside a Sleeve Regulating Valve

Flow Regulation Performance Analysis of Microfluidic Passive Valve for High Throughput Liquid Delivery

Structural Optimization and Mechanical Simulation of MEMS Thin-Film Getter–Heater Unit

CFD Analysis on the Dynamic Flow Characteristics of the Pilot-Control Globe Valve

Numerical Analysis of Flow and Cavitation Characteristics in a Pilot-Control Globe Valve with Different Valve Core Displacements

Simulation analysis and optimization of pilot type electro-hydraulic proportional directional valve based on multi field coupling

Geometrical Variation Analysis of an Electrothermally Driven Polysilicon Microactuator

Numerical investigation of fluid-structure interaction in a pilot-operated microfluidic valve

Fluid-Structure Interaction Analysis on Membrane Behavior of a Microfluidic Passive Valve

The thermal stress analysis in 3D IC integration with TSV interposer