Abstract:Material response and the launch of laser plasma during the 1064 nm nanosecond laser pulse induced damage to the exit surface of fused silica are investigated. Employing a polarization-based two-frame shadowgraphy setup with ～ 60 fs probing resolution, the transient material responses from the rising part of nanosecond pumping pulse to several hundred nanosecond timescale are captured. Using a shearing interferometry setup, the evolution of transient phase shift of laser plasma in the expansion process to the ambient air is also investigated. Inhomogeneous distribution of phase shift caused by the electrons and neutrals in the plasma is quantitatively resolved by employing the fast Fourier transform based filtering algorism. To demonstrate the evolutions of important plasma parameters such as pressure, temperature and density, a continuum hydrodynamic model is numerically solved. The initial pressure of plasma is estimated according to the point-explosion model, and the initial plasma temperature is achieved by calculating the difference between simulating shockwave front radius and experimental value at the same delay. The optimal temperature is chosen when the radius difference is minimal. Main conclusions are as follows. 1) Abundant suprathermal electrons are excited in the early energy deposition process. Part of these electrons contribute to the thermal transport process and produce the laser supported solid-state absorption front (LSSAF) which propagates into the bulk silica. Other electrons escape to the air side and contribute to the formation of air plasma through the impact ionization process. Plasma expansion speed is about 20 km/s during this phase. 2) When the pump pulse is terminated, the LSSAF and air plasma lose their energy supplied and experience a rapid decline of the temperature and expansion velocity. As a result, the final damage crater depth exhibits seldomly no increase compared with the transient crater depth during this phase. Hot bulk plasma formed in this phase becomes the damage precursor and induces the ejection of abundant neutrals probably due to the phase explosion mechanism. Inhomogeneous distribution of stress is formed by Rayleigh-Taylor instability at the interface between hot bulk plasma and surrounding bulk material during the expansion of LSSAF. Radial and circumferential cracks are formed due to the release of stress. 3) Evolution of air plasma follows the conventional evolution process of laser-induced plasma, i. e. , internal pressure, temperature and density decrease quickly with time delay. The simulated transient highest pressure is about 600 MPa. Simulation also predicts the formation of the internal shockwave. Our work will be helpful in understanding the laser damage mechanism of the fused silica optical window.

Residual Stress Near Cracks of K9 and Fused Silica under 1064 Nm Nanosecond Laser Irradiation

Residual Stress Near Cracks of K9 Glass under 1 064-Nm Nanosecond Laser Irradiation

Bulk Damage and Stress Behavior of Fused Silica Irradiated by Nanosecond Laser

Analysis of Temperature and Thermal Stress Fields of K9 Glass Damaged by 1064nm Nanosecond Pulse Laser

Experimental and Computational Study of Damage Pocess Induced by 1064 Nm Nanosecond Laser Pulse on the Exit Surface of Fused Silica

Analysis of Thermal Stress Damage in Single-Crystal Silicon Induced by 1064nm Long Pulse Laser

Photoelasticity-based Stress Field Analysis of Glass under 1064 Nm Laser Irradiation

Quantitative Measurement of CO2laser-induced Residual Stress in Fused Silica Optics

Energy-dependent correlation between micro/nano-morphology and stress state of femtosecond laser-induced modification in fused silica

Effect of residual stress on laser-induced damage characterization of mitigated damage sites in fused silica

Study of the Effects of Stress Wave Behavior in Laser-Induced Exit-Surface Damage of Fused Silica Using Time-Resolved Multi-Polariscopic Imaging

Crack arrest and stress dependence of laser-induced surface damage in fused-silica and borosilicate glass

Numerical Simulation of Thermal Effect in Fused Silica Irradiated by Nanosecond High Repetition Rate Laser

Study on thermal stress of the the fused silica irradiated by millisecond–nanosecond combined pulse laser

Time-Resolved Imaging of Filamentary Damage on the Exit Surface of Fused Silica Induced by 1064 Nm Nanosecond Laser Pulse

Investigation of Stress Wave and Damage Morphology Growth Generated by Laser-Induced Damage on Rear Surface of Fused Silica.

Effects of CO2 Laser Irradiation on Surface Morphology and Stress Distribution of Fused Silica

Behavior of 355 nm laser-induced damage growth in fused silica

Stress in femtosecond-laser-written waveguides in fused silica

Laser-damage Growth Characteristics of Fused Silica under 1064- and 532-Nm Laser Irradiation

X-ray stress measurement of SiC single-crystal induced by laser ablation