Abstract:Material response and the launch of laser plasma during the 1064 nm nanosecond laser pulse induced damage to the exit surface of fused silica are investigated. Employing a polarization-based two-frame shadowgraphy setup with ～ 60 fs probing resolution, the transient material responses from the rising part of nanosecond pumping pulse to several hundred nanosecond timescale are captured. Using a shearing interferometry setup, the evolution of transient phase shift of laser plasma in the expansion process to the ambient air is also investigated. Inhomogeneous distribution of phase shift caused by the electrons and neutrals in the plasma is quantitatively resolved by employing the fast Fourier transform based filtering algorism. To demonstrate the evolutions of important plasma parameters such as pressure, temperature and density, a continuum hydrodynamic model is numerically solved. The initial pressure of plasma is estimated according to the point-explosion model, and the initial plasma temperature is achieved by calculating the difference between simulating shockwave front radius and experimental value at the same delay. The optimal temperature is chosen when the radius difference is minimal. Main conclusions are as follows. 1) Abundant suprathermal electrons are excited in the early energy deposition process. Part of these electrons contribute to the thermal transport process and produce the laser supported solid-state absorption front (LSSAF) which propagates into the bulk silica. Other electrons escape to the air side and contribute to the formation of air plasma through the impact ionization process. Plasma expansion speed is about 20 km/s during this phase. 2) When the pump pulse is terminated, the LSSAF and air plasma lose their energy supplied and experience a rapid decline of the temperature and expansion velocity. As a result, the final damage crater depth exhibits seldomly no increase compared with the transient crater depth during this phase. Hot bulk plasma formed in this phase becomes the damage precursor and induces the ejection of abundant neutrals probably due to the phase explosion mechanism. Inhomogeneous distribution of stress is formed by Rayleigh-Taylor instability at the interface between hot bulk plasma and surrounding bulk material during the expansion of LSSAF. Radial and circumferential cracks are formed due to the release of stress. 3) Evolution of air plasma follows the conventional evolution process of laser-induced plasma, i. e. , internal pressure, temperature and density decrease quickly with time delay. The simulated transient highest pressure is about 600 MPa. Simulation also predicts the formation of the internal shockwave. Our work will be helpful in understanding the laser damage mechanism of the fused silica optical window.

Investigation of Stress Wave and Damage Morphology Growth Generated by Laser-Induced Damage on Rear Surface of Fused Silica.

Study of the Effects of Stress Wave Behavior in Laser-Induced Exit-Surface Damage of Fused Silica Using Time-Resolved Multi-Polariscopic Imaging

Behavior of 355 nm laser-induced damage growth in fused silica

Morphological and Damage Growth Characteristics of Shell-Type Damage of Fused Silica Optics Induced by Ultraviolet Laser Pulses.

Bulk Damage and Stress Behavior of Fused Silica Irradiated by Nanosecond Laser

Experimental and Computational Study of Damage Pocess Induced by 1064 Nm Nanosecond Laser Pulse on the Exit Surface of Fused Silica

Time-Resolved Imaging of Filamentary Damage on the Exit Surface of Fused Silica Induced by 1064 Nm Nanosecond Laser Pulse

Time-resolved Dynamics of 355-Nm Laser-Irradiated Surface Damage on Fused Silica

Laser-Induced Damage on Fused Silica with Photo-Acoustic Method

Stress Waves Induced by Femtosecond Laser Pulse Ablating Silica Glass

Damage Growth Characteristics of Different Initial Damage Sites of Fused Silica under 355 Nm Small Laser Beam Irradiation

Effects of CO2 Laser Irradiation on Surface Morphology and Stress Distribution of Fused Silica

Explosion Plume on the Exit Surface of Fused Silica During UV Laser- Induced Damage

Laser-induced Damage Growth of Fused Silica at 351 Nm on a Large-Aperture High-Power Laser Facility

Laser-Induced Damage on Fused Silica with Photo-Acoustic Spectrum Analysis

Theoretical and Experimental Research on Laser-Induced Damage of Fused Silica Optics Due to Stimulated Brillouin Scattering

Residual Stress Near Cracks of K9 and Fused Silica under 1064 Nm Nanosecond Laser Irradiation

Investigation of the Entrapped Micro Bubble Defect As a High-Energy Laser Damage Precursor in Fused Silica Optics

Non-destructive evaluation of UV pulse laser-induced damage performance of fused silica optics

Study of growth of laser initiated damage in fused silica at 3ω

Laser-damage Growth Characteristics of Fused Silica under 1064- and 532-Nm Laser Irradiation