Fabrication and Characterization of High-Quality Factor Gan-Based Resonant-Cavity Blue Light-Emitting Diodes

Xiao-Long Hu,Wen-Jie Liu,Guo-En Weng,Jiang-Yong Zhang,Xue-Qin Lv,Ming-Ming Liang,Ming Chen,Hui-Jun Huang,Ying,Bao-Ping Zhang
DOI: https://doi.org/10.1109/lpt.2012.2206110
IF: 2.6
2012-01-01
IEEE Photonics Technology Letters
Abstract:High-quality factor (Q > 1700) GaN-based blue resonant-cavity light-emitting diodes (RCLEDs) incorporating an InGaN/GaN multiquantum well active region, two high-reflectivity dielectric-distributed Bragg reflectors, and a thin indium tin oxide (ITO) layer are fabricated by a two-step substrate transfer technique. Electroluminescence measurements showed a narrow linewidth of 0.26 nm at the wavelength of 450.6 nm by precisely placing the ITO layer at the node position of the electric field, corresponding to a high Q-value of 1720. Further, adopting a chemical-mechanical polishing (CMP) technique to polish the GaN surface after the removal of sapphire substrate, an even higher Q-value of 2170 was obtained. This improvement was attributed to the exclusion of the defect-rich buffer layer and the achievement of a smooth surface with a root mean square roughness below 1 nm. The integrated electroluminescence intensity was enhanced by 40% as compared with the RCLEDs without CMP at a current density of 8 kA/cm(2).
What problem does this paper attempt to address?