Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

The effects of cut-out on stress distribution and deformations in laser thermal adjustment

On the competition between in-plane and out-of-plane deformations in laser thermal adjustment

Analysis and Prediction of the In-Plane Deformation in Laser Thermal Adjustment

Numerical and experimental study on bi-direction deformations in laser micro forming of two-bridge actuators

Effects of Unbalanced Thermal Field on Manufacturing Processes in Selective Laser Sintering

The Interactive Effects on Deformation Behavior in Laser Thermal Adjustment of Two-Bridge Actuators

The Process Planning in Laser Thermal Adjustment of Three Cut-Outs Actuators

Thermal deformation behaviors of laser rectangular tube bending

Analysis and Control of Edge Effects in Laser Bending

Effect of different heating methods on deformation of metal plate under upsetting mechanism in laser forming

Bending Angle Estimated Based On Inherent Strain Theory During Laser Forming

Effect of Curvature Radius on the Residual Stress of Thin-Walled Parts in Laser Direct Forming

Study on the Mechanical Behavior of Laser Micro-Adjustment of Two-Bridge Actuators

Mechanism of Laser Micro-Adjustment

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Controlling Edge Effects in Laser Bending

Processing Optimization in Multiheating Positions for Laser Thermal Adjustment of Actuators

Analyses of Effects of Process Parameters on Laser Bending of Stiffened Panels

An Analytical Model for Estimating Deformation in Laser Forming

Research on the mechanisms of laser forming for the metal plate

Thermal Influencing Distribution of Sheet Metal during the Process of Laser Forming