Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Thermal Influencing Distribution of Sheet Metal during the Process of Laser Forming

The Simulation Of Temperature Field In The Laser Forming Of Steel Plates

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Study on Laser Sine Forming of Sheet Metals

Affected Characteristics Analysis of the Pulsed Laser Forming of Metal Sheet

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Research on the mechanisms of laser forming for the metal plate

Explicit Analysis on Temperature Field of 3D Laser Forming of Square Metal Sheet to Spherical Dome

Deformation Behaviors of Laser Forming of Ring Sheet Metals

Simulation investigation the effect of heating-lines on tensile mechanical properties of sheet metal after laser scanning

Analysis on the stress field during 3D laser forming of square sheet to spherical dome

Study on mechanical properties after laser forming

Dynamic Analysis on Laser Forming of Square Metal Sheet to Spherical Dome

Laser Forming of Plates Using Two Sequent Scans of Different Intervals

Investigation of the Effect of Heating-Lines on Tensional Mechanical Properties of Sheet Metal after Laser Forming

Research on the Forming Process of Three-Dimensional Metal Parts Fabricated by Laser Direct Metal Forming

Research On The Characteristics Of Metal Sheet With Pulse Laser Forming

Numerical Study on the Influence of Temperature Field on Laser Bending of Sheet Metals

Process and Development of Laser Forming

NUMERICAL INVESTIGATION OF STRAIGHT-LINE LASER FORMING UNDER THE TEMPERATURE GRADIENT MECHANISM

FEM Realization of Laser Curve Bending Process