Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Study on mechanical properties after laser forming

Research on the mechanisms of laser forming for the metal plate

Theoretical and Experimental Study on Laser Compound Forming of Plate

Effect of Laser Forming on Mechanical Properties of Multiple-Phase Steels by Using a Thermal–microstructure–mechanical Model

Research on the Mechanisms of Laser Forming for the Micro-Structural Element

Affected Characteristics Analysis of the Pulsed Laser Forming of Metal Sheet

Investigation of the Effect of Heating-Lines on Tensional Mechanical Properties of Sheet Metal after Laser Forming

Microstructure and Mechanical Property Characterizations of Metal Foil after Microscale Laser Dynamic Forming

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Research On The Characteristics Of Metal Sheet With Pulse Laser Forming

Preliminary Studies on Strain Rate Dependence of Laser Shock Forming

Experimental Characterization and Strengthening Mechanism of Process-Structure-property of Selective Laser Melted 316 L

Process and Development of Laser Forming

In-situ Investigation of the Anisotropic Mechanical Properties of Laser Direct Metal Deposition Ti6Al4V Alloy

Microstructure response and bending fatigue characteristics of typical positions for the integral stiffened structure of 6005A-T6 aluminum alloy after laser peen forming

Modelling of laser forming – An review

Thermal Influencing Distribution of Sheet Metal during the Process of Laser Forming

Laser Direct Forming of Metal Components: Technical Characterizations

Fatigue and tensile deformation behaviors of laser powder bed fused 304L austenitic stainless steel

An experimental investigation of underwater pulsed laser forming

Effect of Restrain on Deformation of Sheet Metal in Laser Forming