Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Preliminary Studies on Strain Rate Dependence of Laser Shock Forming

Numerical Simulation Research on Laser Shock Forming of Thin Metal Sheet

Numerical Simulation Research on Laser Shock Forming

A study on super-speed forming of metal sheet by laser shock waves

Crystal plasticity–based finite element modeling and experimental study for high strain rate microscale laser shock clinching of copper foil

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Study on numerical simulation of residual stresses induced by laser shock processing

Laser shock micro-bulk forming: Numerical simulation and experimental research

Laser Shock Forming on Coated Metal Sheets Characterized by Ultrahigh-Strain-Rate Plastic Deformation

The Effect of Viscous Drag on the Maximum Residual Stresses Achievable in High-Yield-Strength Materials in Laser Shock Processing

Experimental and numerical investigation on residual stress of 316L SS treated by different laser shock peening parameters

Strain rate dependence of tensile properties and strengthening mechanism of Ti6Al4V alloy undergoing different coverage layers of laser shock peening

Laser shock micro-sheet bulk metal forming: numerical simulation and experimental validation

Residual Stress Field Induced by Laser Peening: a Finite Element Analysis

Numerical investigation on spall fracture in a metallic material caused by laser shock peening

Optimization Of Residual Stresses Induced By Multiple Laser Shock Processing

Stepwise varying of laser parameters to enhance the residual stress field in multiple laser shock processing: numerical verification of single-point region

Effect of in situ laser shock forging on residual stress field induced by selective laser melting

Fatigue life and fracture evolution of small-hole specimens by laser shock processing

Ultrahigh-strain-rate Plastic Deformation of a Stainless-Steel Sheet with TiN Coatings Driven by Laser Shock Waves

Prediction of Residual Stress Random Fields for Selective Laser Melted A357 Aluminum Alloy Subjected to Laser Shock Peening