Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Effect of Laser Forming on Mechanical Properties of Multiple-Phase Steels by Using a Thermal–microstructure–mechanical Model

A thermo-metallurgical-mechanical model for microstructure evolution in laser-assisted robotic roller forming of ultrahigh strength martensitic steel

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Study on mechanical properties after laser forming

Laser-assisted robotic roller forming of an ultrahigh strength martensitic steel

Simulation investigation the effect of heating-lines on tensile mechanical properties of sheet metal after laser scanning

Research on the Mechanisms of Laser Forming for the Micro-Structural Element

Modelling of laser forming – An review

Research on the mechanisms of laser forming for the metal plate

Prediction on the Mechanical and Forming Behaviors of Ferrite-Martensite Dual Phase Steels Based on a Flow Model

Influence of hot forming on microstructure and mechanical properties of laser tailor-welded dissimilar ultra-high-strength steels

Bending Angle Estimated Based On Inherent Strain Theory During Laser Forming

Effect of Local Laser Heat Treatment on Formability of DP1180 Dual-phase Steel

Unveiling the Cellular Microstructure–property Relations in Martensitic Stainless Steel Via Laser Powder Bed Fusion

The effects of solid-state phase transformation upon stress evolution in laser metal powder deposition

A Multi-Phase Model for High Strength Steels

Deformation Behaviors of Laser Forming of Ring Sheet Metals

A thermal–metallurgical model of laser beam welding simulation for carbon steels

Analyses of Effects of Process Parameters on Laser Bending of Stiffened Panels

Thermo-physical phase field model of laser powder melting additive manufacturing of 2D layered stainless steel structures

Numerical Modeling and Mechanism Analysis of Hybrid Heating and Shock Process for Laser-Assisted Laser Peen Forming