Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Laser-assisted robotic roller forming of an ultrahigh strength martensitic steel

A thermo-metallurgical-mechanical model for microstructure evolution in laser-assisted robotic roller forming of ultrahigh strength martensitic steel

Laser-Assisted Robotic Roller Forming of Ultrahigh-Strength Steel QP1180 with High Precision

Local laser softening of press-hardened steel at high feed rates

Local laser softening of high-strength steel with an adapted intensity

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Microstructure and Mechanical Property Characterizations of Metal Foil after Microscale Laser Dynamic Forming

Unveiling the Cellular Microstructure–property Relations in Martensitic Stainless Steel Via Laser Powder Bed Fusion

Laser Treatment for Strengthening of Thin Sheet Steel

Influence of hot forming on microstructure and mechanical properties of laser tailor-welded dissimilar ultra-high-strength steels

Surface heterostructuring in laser-treated alloys through local austenitization for high strength and formability

Experimental and numerical investigation on laser beam forming of steel sheets

Preparation of high-performance SA508 Grade 3 steel by laser powder bed fusion: role of high cooling rate on microstructure and mechanical properties

Revealing the Enhancement Mechanism of Laser Cutting on the Strength–Ductility Combination in Low Carbon Steel

Microstructure distribution and bending fracture mechanism of 65Mn steel in the laser surface treatment

Microstructural evolution and mechanical properties of laser repaired 12Cr12Mo stainless steel

Microstructure and Wear Behavior of Laser-Remelted High-Manganese Steel

Laser Heat Treatment of Low-Alloy Ultrahigh-Strength Steel Laser-Welded Joints

Characterization of the deformation behavior and microstructure evolution in laser bending of TC4 titanium alloy heavy plate

Bending Forming Characteristics of CoCrFeMnNi High-Entropy Alloy Sheets Induced by Nanosecond Pulse Laser Irradiation

Microstructure and Property of Laser Transformation Hardening on Sheet Steel with High Carbon Content