Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Laser Treatment for Strengthening of Thin Sheet Steel

Feasibility Evaluation of Local Laser Treatment for Strengthening of Thin-Walled Structures from Low-Carbon Steel Subjected to Bending

Local laser softening of high-strength steel with an adapted intensity

Local laser softening of press-hardened steel at high feed rates

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Experimental Characterization and Strengthening Mechanism of Process-Structure-property of Selective Laser Melted 316 L

Experimental and numerical investigation on laser beam forming of steel sheets

Laser-assisted robotic roller forming of an ultrahigh strength martensitic steel

Laser shock peening on high-strength steel

Experimental Characterization and Yield Strength Model for Process-Structure-Property of Selective Laser Melted 316L

Surface heterostructuring in laser-treated alloys through local austenitization for high strength and formability

Influence of laser beam process parameters on the bending ability of Ti-6Al-4V titanium alloy sheets

Influence of the initial structure on the efficiency of laser processing of steel

Influence of laser treatment on the microstructural evolution and performance of Ti65 alloy

Investigation of Two Laser Heat Treatment Strategies for Local Softening of a Sheet in Age-Hardening Aluminum Alloy by Means of Physical Simulation

Effect of Laser Heat Treatment on Bending Property of Laser Welded Joints of Low-Alloy Ultra-High Strength Steel

Characterization of the deformation behavior and microstructure evolution in laser bending of TC4 titanium alloy heavy plate

Laser-Assisted Robotic Roller Forming of Ultrahigh-Strength Steel QP1180 with High Precision

STUDY ON LASER BENDING OF TITANIUM ALLOYS SHEETS

Examination of steel compatibility with additive manufacturing and repair via laser directed energy deposition

Laser Heat Treatment of Low-Alloy Ultrahigh-Strength Steel Laser-Welded Joints