Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Simulation investigation the effect of heating-lines on tensile mechanical properties of sheet metal after laser scanning

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Experimental Characterization and Strengthening Mechanism of Process-Structure-property of Selective Laser Melted 316 L

Experimental Characterization and Yield Strength Model for Process-Structure-Property of Selective Laser Melted 316L

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Effect of laser scanning speed on the thermal-mechanical coupling field of laser remelting of valve seat

Unveiling the Cellular Microstructure–property Relations in Martensitic Stainless Steel Via Laser Powder Bed Fusion

A Review on Modelling and Simulation of Laser Additive Manufacturing: Heat Transfer, Microstructure Evolutions and Mechanical Properties

Study on Thermodynamic Behavior, Microstructure and Mechanical Properties of Thin-Walled Parts by Selective Laser Melting

Experimental study on the effect of scanning path on skin tissue properties of femtosecond laser welding

Effect of laser scanning speed on the microstructure, phase transformation and mechanical property of NiTi alloys fabricated by LPBF

Thermal Stress Field and Microstructure Evolution of Ti-6Al-4V Fabricated by Laser Engineered Net Shaping

Effect of Scanning Modes on the Tensile Strength and Stability in Laser Skin Welding in Vitro

A thermal–metallurgical model of laser beam welding simulation for carbon steels

Effects of Scanning Mode on Microstructure and Mechanical Properties of Copper Joint Fabricated by Electron Beam Welding

Effect of Dynamic Preheating on the Thermal Behavior and Mechanical Properties of Laser-Welded Joints

In-situ investigation on tensile deformation and fracture behaviors of inhomogeneous microstructure during laser repair of Ti-6Al-4 V titanium alloy

Deformation Behaviours of Laser Curve Bending of Sheet Metals

Numerical and experimental study on thermal-metallurgical-mechanical behavior of high-strength steel welded joint

Stress evolution mechanisms under different SSPT-related effects during laser welding

Effect of Heat Input on Microstructure and Mechanical Properties of Laser Welded Medium Mn Steel Joints