Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Controlling Edge Effects in Laser Bending

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Research on Precision Control of Sheet Metal Forming by Laser Shock Waves with Semi-Die

Edge effect reduction in laser bending of DP980 high-strength steel

Recent Advances in the Laser Forming Process: A Review

Real-time monitoring of temperature gradients and bending mechanism in multi-scan laser forming process

Research on Bending Angels of Laser Peen Forming Without Confine Layer

Experimental and numerical investigation on laser beam forming of steel sheets

Process and Development of Laser Forming

The Effect of Elastic Pre-Bending on the Laser Peen Forming of 2024-T351 Aluminum Alloy Plate

The saturated convex bending curvature of 7075 aluminum panel bent by orthogonal laser shock forming

Making Light Work of Metal Bending: Laser Forming in Rapid Prototyping

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model

Numerical Simulation Research on Laser Shock Forming of Thin Metal Sheet

Design of an innovative laser-assisted four-point bending forming process for high-stiffened structure of aluminum alloy

Bending Forming Characteristics of CoCrFeMnNi High-Entropy Alloy Sheets Induced by Nanosecond Pulse Laser Irradiation

Multi-scale finite element analysis of laser-assisted forming of CF/PEEK composite corner structures

Effects of Laser Scanning Strategy on Bending Behavior and Microstructure of DP980 Steel

Sidewall shape control using direct laser fabrication technology

Reducing the Rebound Effect in Microscale Laser Dynamic Forming through Multi-Pulse Laser Shock Loading

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal