Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Research on Bending Angels of Laser Peen Forming Without Confine Layer

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

The Effect of Elastic Pre-Bending on the Laser Peen Forming of 2024-T351 Aluminum Alloy Plate

Design of an innovative laser-assisted four-point bending forming process for high-stiffened structure of aluminum alloy

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model

Experimental and Numerical Simulation of Sheet Bulging Induced by Laser Shock Peening

Real-time monitoring of temperature gradients and bending mechanism in multi-scan laser forming process

Comprehensive Analysis of Laser Peening Forming Effects on 5083 Aluminum Alloy

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Experimental and numerical investigation on laser beam forming of steel sheets

Influence of laser beam process parameters on the bending ability of Ti-6Al-4V titanium alloy sheets

Bending Forming Characteristics of CoCrFeMnNi High-Entropy Alloy Sheets Induced by Nanosecond Pulse Laser Irradiation

STUDY ON LASER BENDING OF TITANIUM ALLOYS SHEETS

Numerical Simulation Research on Laser Shock Forming of Thin Metal Sheet

Modeling Research for Plate Pre-Loading of Laser Peening Forming

Parameter Optimization for Laser Peen Forming on 6005A-T6 Aluminum Alloy Plates to Enhance the Constrained Deformation of Integral Stiffened Plates

Process and Development of Laser Forming

Recent Advances in the Laser Forming Process: A Review

Research on Precision Control of Sheet Metal Forming by Laser Shock Waves with Semi-Die

Studies on Laser Forming of Ti–6Al–4V Alloy Sheet

The saturated convex bending curvature of 7075 aluminum panel bent by orthogonal laser shock forming