Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Studies on Laser Forming of Ti–6Al–4V Alloy Sheet

Influence of laser beam process parameters on the bending ability of Ti-6Al-4V titanium alloy sheets

STUDY ON LASER BENDING OF TITANIUM ALLOYS SHEETS

Curved Laser Bending of Titanium Alloy Sheets and Effects of Heat Radiation on Its Microstructure and Property

Investigation on the Microstructure and Mechanical Behaviors of a Laser Formed Nb-Ti-Al Alloy

Characterization of the deformation behavior and microstructure evolution in laser bending of TC4 titanium alloy heavy plate

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

In-Situ Tensile Deformation Behavior Of As-Built Laser Direct Metal Deposited Ti-6al-4v Alloy At 200 Degrees C

Bending Forming Characteristics of CoCrFeMnNi High-Entropy Alloy Sheets Induced by Nanosecond Pulse Laser Irradiation

Deformation Behaviours of Laser Curve Bending of Sheet Metals

In-situ Investigation of the Anisotropic Mechanical Properties of Laser Direct Metal Deposition Ti6Al4V Alloy

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Deformation and control method of thin-walled part during laser powder bed fusion of Ti–6Al–4V alloy

In-situ investigation into the deformation behavior of Ti-6Al-4V processed by laser powder bed fusion

Hot Tensile Deformation Behavior of Ti-6Al-4V Titanium Alloy Made by Laser Melting Deposition

On the Laser Forming Process of 6061 Aluminium Alloy Sheets with Angular Segment Irradiating Scheme: A Numerical and Statistical Investigation

Bending Properties and Fracture Behavior of Ti-23Al-17Nb Alloy Laser Beam Welding Joints

Process and Development of Laser Forming

Influence of laser treatment on the microstructural evolution and performance of Ti65 alloy

The Effect of Elastic Pre-Bending on the Laser Peen Forming of 2024-T351 Aluminum Alloy Plate

In-situ Comparison of Deformation Behavior at 23 ℃ and 650 ℃ of Laser Direct Melting Deposited Ti-6Al-4V Alloy