Abstract:Adopting the sidewall-insulated hollow electrode (SIHE) is an ideal approach to achieve electrolyte-refresh and stray corrosion inhibition functions in micro electrochemical machining (ECM) processes. Most of the traditional SIHEs are made of metal substrate and non-metal thin films. The insulating film has poor durability, and the preparation approach of the traditional SIHE is complex and has limited repeatability. This research presents a novel structure of a SIHE with an insulated substrate and an internal conductive film. The machining performance of the novel SIHE is primarily verified by a potential distribution analysis in the numerical simulation. According to the concept of the novel SIHE, a silver-plated glass tube electrode (SPGTE) is presented: the glass tube acts as the insulated substrate, and the plated silver layer acts as the working cathode. Then, a fabrication process for the SPGTE is proposed. Silver layers are tightly bonded on the glass tube surface by electroless plating. The thickness of the silver layer is approximately 3.5 mu m, and its electrical resistivity is approximately 5 x 10-5 omega cm. In micro ECM experiments, microstructures with steep sidewalls with taper angles of <5<degrees> are machined, which is attributed to the stray corrosion inhibition of the insulated substrate. Micro holes with an aspect ratio of approximately 3 are machined. There is no accumulation of electrolytic products and short circuits, which verifies the excellent electrolyte-fresh performance. Compared with the traditional SIHEs, the novel SIHE could provide a simpler and more reliable way of fabricating sidewall-insulated electrodes. The proposed electrode structure can further inspire new electrode preparation schemes based on new substrate materials and film preparation approaches.

Experimental Study of Micro Electrochemical Milling with Side-Insulated Electrode

Research on Side-Insulation of Tool Electrode for Micro Electrochemical Machining

Experimental Study on Micro Electrochemical Machining with Hydrophobic Side Insulation Electrode

Side-Insulation of Tool Electrode and Application in Micro ECM

Silicon-based Tool Electrodes for Micro Electrochemical Machining

Influence of Side-Insulation Film on Hybrid Process of Micro EDM and ECM for 3D Micro Structures

A Shunt-Assisted Silicon Electrode for Micro Electrochemical Machining

Effect of Anisotropically-etched Silicon Electrode on Electrolytic Products Flow in Micro ECM

Research On Micro Ecm Using Micro Array Electrode

Study on Micro-hole Electrochemical Machining Process with Sidewall-insulated Tool Electrode

Experimental investigation of rotary sinking electrochemical discharge milling with high-conductivity salt solution and non-pulsed direct current

Fabrication Technology and Investigation of Silicon-based Tool Electrodes for Micro ECM

Novel Structure Of A Sidewall-Insulated Hollow Electrode For Micro Electrochemical Machining

Sinking ECDM micro-milling of micro-channels with a customized electrode

Fabrication of a Tool Electrode with Hydrophobic Features and Its Stray-Corrosion Suppression Performance for Micro-electrochemical Machining

Analysis and Experimental Study of Micro ECM with Intermittent Retraction of Electrode

Research On Micro Electrode Fabrication Based On Ecm

A study on wire electrochemical micromachining for fabrication of microgrooves

Selection and Optimization of Electrolyte for Micro Electrochemical Machining on Stainless Steel 304

A study of micro-EDM and micro-ECM combined milling for 3D metallic micro-structures

A Profile Shaping and Surface Finishing Process of Micro Electrochemical Machining for Microstructures on Microfluidic Chip Molds