Abstract:The foamed structure of the central layer, predominantly governed by the addition levels of TiH 2 and the composition of the precursor, in addition to the parameters associated with the foaming process, constitutes the pivotal determinant impacting the spectrum of applications for aluminum foam sandwiches. Systematic research on the foaming behavior of the AlMg 4 Si 8 matrix and pure Al matrix precursors in closed cavities with different TiH 2 addition levels was conducted. The results reveal that with the increasing amount of TiH 2 , specifically at a 200% expansion rate of AlMg 4 Si 8 foams, the number of large pores decreased, the average pore size decreased from 0.67 mm 2 (0.6 wt%) to 0.43 mm 2 (1.0 wt%), and the total number of pores increased from 125 (0.6 wt%) to 156 (1.0 wt%). This trend of pore size consistency was evident not only at the mentioned 200% expansion rate but also across different expansion rates of AlMg 4 Si 8 foams and across all expansion rates of pure Al foams. The pore structures observed in the AlMg 4 Si 8 matrix and pure aluminum matrix foams within a closed cavity exhibited significantly superior characteristics compared to those achieved through free foaming processes. The circularity of pure Al foams was mainly distributed in the range of 1–2, being higher than the AlMg 4 Si 8 foams (1–1.5) due to their low viscosity and foam stability. The compressive curve of AlMg 4 Si 8 foams at a 400% expansion rate reveals that as the average cross-sectional area increased, there was a higher likelihood of experiencing initial collapse conditions. Additionally, the fluctuation of the platform area became more pronounced. Further, the slope corresponding to the elastic stage of the compressive curve increased as the overall stress levels increased.

Synthesis of Al Foams with Al Powder for Increasing Viscosity

Development of AlMg35-TiH2 composite foaming agent and fabrication of small pore size aluminium foams

Foaming Process and Properties of 6063 Aluminum Foams by Melt Foaming Method

Preparation of Aluminum Foam Using Novel Foaming Agent

Optimization of Cellular Structure of Aluminum Foams Produced by Powder Metallurgy Method

Preparation of Foamed Aluminum with Controllable Size of Pore

Effect of TiH2 addition on pore structures of aluminum foam prepared by power metallurgy route

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Effects of process parameters and alloy compositions on the pore structure of foamed aluminum

THE PRODUCTION OF FOAM ALUMINUM BY USE OF MOLTEN ALUMINUM FOAMING METHOD

Novel Foaming Agent Used in Preparation Process of Aluminum Foams

The investigation of powder process for making Al foams

Fabrication of Al Foam Without Thickening Process Through Melt-Foaming Method

Optimizing Calcium Addition for Fabricating Aluminum Foams with Different Pore Sizes

Multifunctional Foaming Agent to Prepare Aluminum Foam with Enhanced Mechanical Properties

Foaming Behavior of AlMg4Si8 Matrix and Pure Al Matrix Precursors in Closed Cavities with Different TiH2 Addition Levels

Study of Foaming Efficiency and Cells Uniformity of Aluminum Foam

Evolution of Pore Morphology and Cell Wall Microstructure of Aluminum Foam During Powder Metallurgical Foaming

Influence of Foaming Temperature on the Pore Structure of Aluminum Foam and Analysis of Its Mechanism

Preparation of Aluminum Foam by Gas Injection Foaming