Abstract:Aluminum foam that is lightweight with high specific strength, high energy absorption and other characteristics can be used in aerospace, transportation, machinery manufacturing and other fields. The PCM method is usually used to prepare closed-cell aluminum foams. The microsized aluminum foams made by this process can solve the non-uniform pore structures caused by liquid drainage during the foaming process of large aluminum foams. The surface morphology and internal pore structure of microsized aluminum foams are affected by the quality of the precursor used for foaming. In this paper, foamable precursors were obtained via either hot rolling or hot extrusion and subsequently foamed. By analyzing the micromorphology and foaming process of the precursor, the influence of the technological method on the macroscopic pore structure of the final aluminum foam was studied. The results show that the aluminum powder particles in the precursor prepared with the hot rolling method had metallurgical bonding, and the outer surface was dense, with almost no porosity and holes in the interior. The microsized aluminum foam obtained after foaming was smooth in appearance, and the internal pore structure was round and uniform. The reason is that during the foaming process of microsize aluminum foam, the foaming agent was evenly distributed in the precursor of the hot rolling process because of its compact structure. During the foaming process, the decomposed gas of the foaming agent will not escape, and the evenly distributed foaming agent tends to nucleate in situ. In the process of rapid foaming, the pressure in the bubble is enough to resist the liquid drainage phenomenon caused by gravity, and the growth direction of the gas core is isotropic, which promotes the foam structure to be more rounded and uniform.

Study of Foaming Efficiency and Cells Uniformity of Aluminum Foam

Factors affecting the microstructure of a fine ceramic foam

Study on an Aluminum Foam by Gas Injection Foaming

Foaming Process and Properties of 6063 Aluminum Foams by Melt Foaming Method

Effects of process parameters and alloy compositions on the pore structure of foamed aluminum

THE EFFECT OF AL2O3 AND STIRRING TIME ON DENSITY AND POROSITY OF ALUMINUM ADC12 FOAM

The influence of pure Al and hypoeutectic Al Si alloy base materials on the cell structures of aluminum foams produced by gas injection foaming process

Foaming Behavior of Microsized Aluminum Foam Using Hot Rolling Precursor

Optimizing Calcium Addition for Fabricating Aluminum Foams with Different Pore Sizes

Effect of Shape of Pore Forming Agent on Structure and Properties of Aluminum Foams

Characterization of as-cast microstructure of aluminum foams by melt foaming method

Preparation of Aluminum Foam by Gas Injection Foaming

Microstructure and Compressive Properties of Aluminum Foams Made by 6063 Aluminum Alloy and Pure Aluminum

Development of AlMg35-TiH2 composite foaming agent and fabrication of small pore size aluminium foams

Solidification microstructure and grain refinement of closed-cell aluminum foams

The influence of process parameters on the preparation of closed-cell aluminum foam by friction stir processing

The Influences of Process Parameters on the Preparation of Closed-cell Aluminum foam by Friction Stir Processing

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Factors Influencing Foam Height in Gas Injection Process for Aluminum Foams

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization