Abstract:Flashover voltage of contaminated insulators relates to the damp degree of pollution layer on the insulators.Humidity and temperature-difference are two typical factors for dirty layer wetting.We introduced the roles of temperature and humidity in about one-hour short-term wetting of contamination layer.A series of artificial pollution trials,including temperature difference trials and humidity trials,were designed in a temperature and humidity controllable fog chamber.A solid layer method was adopted in the artificial pollution tests,during which ceramic suspension insulators XP-70 were contaminated by brushing specified quantity pollution.Experimental results suggest that when relative humidity(RH) does not reach to 100% and RH as the only factor for wetting,wetting process of dirty layer is very slow and one-hour is not enough to fully damp dirty,thus the NaCl in the contamination cannot be dissolved absolutely and the contribution of NaCl to the conductivity of surface pollution is limited.When the RH reaches to 100% with no temperature difference,contamination can be immediately wetted.Researches also show that temperature difference plays an important role during short-term wetting process.The difference between insulators temperature and the dew point of environment directly affects the strength of leakage current.Temperature difference only in the initial period of wetting plays a dominate role.With the disappearing of temperature difference,humidity becomes the leading factor for dirty damp.The maintenance time of temperature difference playing a leading role in wetting is related to the radiating area and specific heat capacity of the test sample.The smaller the specific is,or the larger the radiating area is,the shorter time the temperature-difference works.

Influence of Contaminant with Sugar on Outer Insulation Performances of Insulator in Substation

Influence of Sugar As A Contaminant on Outdoor Insulation Characteristics of Insulators in A Substation

Analysis on Contamination Discharges of External Insulation in 500 Kv Gangcheng Substation

Mechanism of contaminant accumulation and flashover of insulator in heavily polluted coastal area

Analysis of the Contamination of Insulators Using the Partial Surface Conductivity Method

Influence of Temperature Difference on Wetting Characteristics of Insulators

Experimental Study on the Contamination Deposition Characteristics of Insulators in a Fog–haze Environment

Temporal and spatial characteristics of soluble salt components accreted on the insulator surface

Discharge Behavior and Morphological Characteristics of Suspended Water-Drop on Shed Edge during Rain Flashover of Polluted Large-Diameter Post Insulator

Natural Contamination Deposition Characteristics Based on Natural Contamination Testing Station

Study on the Contamination Distribution Along ±500k VDC Composite Insulator

Roles of Humidity and Temperature Difference in Pollution Layer Wetting of Insulators

Study on Flashover Performance of Post Insulator for 750 Kv Transformer Substation in High Altitude Area

Effects of Natural Contamination Components on the Surface Conductivity under Saturated Moisture

Comparison of On-load Voltage Methods in Artificial Contamination Test for Insulators

Experimental investigation the impact of electric discharge on ice accretion

Investigation on Hydrophobicity and Pollution Status of Composite Insulators in Contaminated Areas

Anti-icing Mechanism and Operation Performance Research of Insulator String by Using Semiconductive Coating Based on Switch-off Effect

Study on Selection Method of External Insulation and Insulator Type Selection for 750 Kv Transmission and Transformation Equipment in High Altitude Area

Assessment of Insulator Pollution Degree Based on Contamination Moisture With Temperature Change

Pollution Flashover Performance of Converter Station Post Insulators at High Altitude Area