Abstract:How to determine the contamination degree is a hot topic of outdoor insulation. Many researchers overseas and domestic have been exploring the measuring methods of contamination degree of outdoor insulation for a long time, several methods have been found and surface conductivity method is one of them. The measuring condition of overall surface conductivity method is identical with the operation condition of insulators used in real overhead transmission lines, so it is a good method to measure contamination degree and can reflect the real contamination states of outdoor insulation, however it needs high voltage, heave and costly equipment and is seriously affected by the air gap between end fitting and contamination on the insulator. Therefore, a new method - partial surface conductivity method is put forward, it can overcome all the drawbacks of overall surface conductivity method. In addition, The measuring process of partial surface conductivity method is very simple and will not destroy the contamination layers of outdoor insulation and can very easily measure out the distribution of contamination on the surface of insulators, this has great significance to the study of insulator contamination. But now the studies to this method are very few and the relation between overall and partial surface conductivity method is not very clear. This paper has a deep study of the relations between overall and partial surface conductivity method on rectangular glass board, RTV board and triangular glass board. The result is that when the artificial contamination on the sample plates is fully damped, the measuring value of overall and partial surface conductivity method is proximately same.

Analysis of the Contamination of Insulators Using the Partial Surface Conductivity Method

Study on the Pollution Regularity of Insulator Using Partial Conductivity Method

Study on the Polluted Regularity of Insulators Quantitatively Described by Partial Surface Conductivity

Study On The Pollution Regularity Of Insulator Using

Novel Method to Measure Contamination on the Hydrophobic Surface of Insulator

Temporal and spatial characteristics of soluble salt components accreted on the insulator surface

The comparative study of overall and partial surface conductivity method

Influence of Partial Electric Arc on the Contamination Degree Monitoring System in View of Leakage Current

Study on the Contamination Distribution Along ±500k VDC Composite Insulator

Cleaning Effect of Rainfall on Surface Contamination of Insulators

Assessment of Insulator Pollution Degree Based on Contamination Moisture With Temperature Change

Study on Method and Device Used for Evaluating the Contamination Condition on the Surface of Composite Insulator

Natural Contamination Deposition Characteristics Based on Natural Contamination Testing Station

Measurement of Contamination Distribution on the Hydrophobic Surface of Insulators by a Partial Surface Conductivity Method

Effects of Natural Contamination Components on the Surface Conductivity under Saturated Moisture

Investigation on Hydrophobicity and Pollution Status of Composite Insulators in Contaminated Areas

A Low-Cost Evaluation and Correction Method for the Soluble Salt Components of the Insulator Contamination Layer

Evaluation of Electrical Insulation Properties on Aged Composite Insulators in Heavily Contaminated Areas

Investigation on Composite Insulators in Contaminated Areas

Experimental Study on the Contamination Deposition Characteristics of Insulators in a Fog–haze Environment

Natural Pollution Test of Composite and Porcelain Insulators Under AC and DC Stress