Abstract:Flashover on polluted insulators is the most common accident occuring in power system. A great amount of work has been done to study the flashover characteristics on various kinds of insulators with several theoretical models proposed. In these models, the amount and the distribution of the pollution on the insulator is critical to the flashover performance. However, very few simulation works has been carried out to study the pollution accumulation characteristics on the insulators. In this paper, both experimental and numerical efforts were given to study the pollution accumulation characteristics in order to evaluate the flashover probability. Experiments were performed first to have a bird view on the overall pollution distributions considering several crucial influential factors such as the wind speed and wind direction. AC porcelain insulators （XWP2-160 type） were selected as the experimental samples and the equiva lent salt deposit density （ESDD） was measured after the total predetermined amount of pollution was reached. Then, aerodynamic simulation was carried out to study the airflow and velocity distributions on each part of the insulator in clean air with regard to different wind speed and direction. It was found that the amount of the pollution on each see tion of the insulator has clear connections to the wind speed or air pressure distribution on the insulator surface. These distributions coincide to the pollution distribution obtained from experiments. Besides, the wind speed and air pressure distribution along the insulator chain was also studied. This work has shown that the numerical simulation may predict the pollution distribution on the insulators with practical accuracy. It is also possible to design new insulator shapes to reduce the pollution accumulation on critical areas according to the analysis in this work.

Temporal and spatial characteristics of soluble salt components accreted on the insulator surface

Effects of Natural Contamination Components on the Surface Conductivity under Saturated Moisture

A Low-Cost Evaluation and Correction Method for the Soluble Salt Components of the Insulator Contamination Layer

Study on Artificial Contamination Test of Typical Transmission Line Insulators

Measurement of Saturated Water Absorption of the Contamination Layer Deposited on Insulator Surface

Analysis of the Contamination of Insulators Using the Partial Surface Conductivity Method

Mechanism of contaminant accumulation and flashover of insulator in heavily polluted coastal area

Experimental Study on the Contamination Deposition Characteristics of Insulators in a Fog–haze Environment

Effect of Soluble Salt on Conductivity of Partial Surface

Study on Method and Device Used for Evaluating the Contamination Condition on the Surface of Composite Insulator

Natural Contamination Deposition Characteristics Based on Natural Contamination Testing Station

Study on the Contamination Distribution Along ±500k VDC Composite Insulator

Contamination Prediction on Insulators Considering of Meteorology,Geomentric Parameters and Air Pollutant

Characterisation Parameter of Atmospheric Pollutant Concentration for External Insulation

Experimental and Numerical Study of the Pollution Accumulation on Outdoor Insulators

Study on the Polluted Regularity of Insulators Quantitatively Described by Partial Surface Conductivity

Equivalent Investigation of Natural Contamination and Artificial Contamination Test

Study on pollution accumulation characteristics of typical insulators

Effective Equivalent Salt Deposit Density of Polluted Silicone Rubber Insulators in Wetting Process

A Study on Streamer Discharge Characteristics along Contaminated Insulator Surface for Different Altitude Regions

Study On The Pollution Regularity Of Insulator Using