Abstract:Flashover on polluted insulators is the most common accident occuring in power system. A great amount of work has been done to study the flashover characteristics on various kinds of insulators with several theoretical models proposed. In these models, the amount and the distribution of the pollution on the insulator is critical to the flashover performance. However, very few simulation works has been carried out to study the pollution accumulation characteristics on the insulators. In this paper, both experimental and numerical efforts were given to study the pollution accumulation characteristics in order to evaluate the flashover probability. Experiments were performed first to have a bird view on the overall pollution distributions considering several crucial influential factors such as the wind speed and wind direction. AC porcelain insulators （XWP2-160 type） were selected as the experimental samples and the equiva lent salt deposit density （ESDD） was measured after the total predetermined amount of pollution was reached. Then, aerodynamic simulation was carried out to study the airflow and velocity distributions on each part of the insulator in clean air with regard to different wind speed and direction. It was found that the amount of the pollution on each see tion of the insulator has clear connections to the wind speed or air pressure distribution on the insulator surface. These distributions coincide to the pollution distribution obtained from experiments. Besides, the wind speed and air pressure distribution along the insulator chain was also studied. This work has shown that the numerical simulation may predict the pollution distribution on the insulators with practical accuracy. It is also possible to design new insulator shapes to reduce the pollution accumulation on critical areas according to the analysis in this work.

Study on the Polluted Regularity of Insulators Quantitatively Described by Partial Surface Conductivity

Study on the Pollution Regularity of Insulator Using Partial Conductivity Method

Analysis of the Contamination of Insulators Using the Partial Surface Conductivity Method

Study of DC Arc Characteristics on Polluted Silicon Rubber Surface

Study On The Pollution Regularity Of Insulator Using

Effects of Natural Contamination Components on the Surface Conductivity under Saturated Moisture

Study on the Contamination Distribution Along ±500k VDC Composite Insulator

Influence of Pollution Manners on DC Pollution Flashover Characteristics of Porcelain Insulators

Experimental research on pollution flashover voltage and leakage current characteristics of naturally polluted insulators

Experimental and Numerical Study of the Pollution Accumulation on Outdoor Insulators

Influence of Organic Pollutants on the Pollution Flashover Properties of Porcelain Insulators

A Low-Cost Evaluation and Correction Method for the Soluble Salt Components of the Insulator Contamination Layer

Temporal and spatial characteristics of soluble salt components accreted on the insulator surface

The comparative study of overall and partial surface conductivity method

Mechanism of contaminant accumulation and flashover of insulator in heavily polluted coastal area

Effective Equivalent Salt Deposit Density of Polluted Silicone Rubber Insulators in Wetting Process

Analysis On Flashover Performance Of Polluted Porcelain Insulators In High Conductivity Fog Environment

Evaluation of Contamination Levels of Outdoor Insulators Based on the Principal Components Analysis of Leakage Current Pulses

Study on Artificial Contamination Test of Typical Transmission Line Insulators

Experimental Study on the Contamination Deposition Characteristics of Insulators in a Fog–haze Environment

Influence of Partial Electric Arc on the Contamination Degree Monitoring System in View of Leakage Current