Abstract:How to determine the contamination degree is a hot topic of outdoor insulation. Many researchers overseas and domestic have been exploring the measuring methods of contamination degree of outdoor insulation for a long time, several methods have been found and surface conductivity method is one of them. The measuring condition of overall surface conductivity method is identical with the operation condition of insulators used in real overhead transmission lines, so it is a good method to measure contamination degree and can reflect the real contamination states of outdoor insulation, however it needs high voltage, heave and costly equipment and is seriously affected by the air gap between end fitting and contamination on the insulator. Therefore, a new method - partial surface conductivity method is put forward, it can overcome all the drawbacks of overall surface conductivity method. In addition, The measuring process of partial surface conductivity method is very simple and will not destroy the contamination layers of outdoor insulation and can very easily measure out the distribution of contamination on the surface of insulators, this has great significance to the study of insulator contamination. But now the studies to this method are very few and the relation between overall and partial surface conductivity method is not very clear. This paper has a deep study of the relations between overall and partial surface conductivity method on rectangular glass board, RTV board and triangular glass board. The result is that when the artificial contamination on the sample plates is fully damped, the measuring value of overall and partial surface conductivity method is proximately same.

Study on Method and Device Used for Evaluating the Contamination Condition on the Surface of Composite Insulator

Novel Method to Measure Contamination on the Hydrophobic Surface of Insulator

A Low-Cost Evaluation and Correction Method for the Soluble Salt Components of the Insulator Contamination Layer

Measurement of Saturated Water Absorption of the Contamination Layer Deposited on Insulator Surface

A novel method of detecting contamination state on the hydrophobic surface

Temporal and spatial characteristics of soluble salt components accreted on the insulator surface

Concept and Test Method of Effective Equivalent Salt Deposit Density for Silicone Rubber Composite Insulators

Properties of Composite Insulating Materials Under Special Contamination

Analysis of the Contamination of Insulators Using the Partial Surface Conductivity Method

Study on the Pollution Regularity of Insulator Using Partial Conductivity Method

Artificial pollution test and pollution performance of composite insulators

Study On The Pollution Regularity Of Insulator Using

Investigation on Composite Insulators in Contaminated Areas

Study on Artificial Contamination Test of Typical Transmission Line Insulators

Study on the Contamination Distribution Along ±500k VDC Composite Insulator

Effects of Natural Contamination Components on the Surface Conductivity under Saturated Moisture

Study on Measurement of Grounding Current and Its Characteristics for Composite Insulator

The comparative study of overall and partial surface conductivity method

Contamination Prediction on Insulators Considering of Meteorology,Geomentric Parameters and Air Pollutant

Measurement of Contamination Distribution on the Hydrophobic Surface of Insulators by a Partial Surface Conductivity Method

Evaluation of Electrical Insulation Properties on Aged Composite Insulators in Heavily Contaminated Areas