Abstract:Contamination withstand performance of power equipment adopting silicon rubber as external insulation is dominated by its hydrophobicity. To reveal hydrophobicity transfer mechanism of various non-soluble pollutant on silicon rubber surface, several inert materials of similar chemical component were selected, including Kaolin, Kieselguhr, and silicon dioxide microspheres. Static contact angle tests at various transfer times are performed to obtain the hydrophobicity transfer characteristics of various pollutants. Scanning electron microscope (SEM) test and mercury intrusion porosimetry (MIP) of these inert materials are also carried out to observe the topographical microstructure. Results show that the variations between static contact angle and hydrophobicity transfer time perform great distinction depending on the microscopic properties of inert material. According to MIP and SEM analysis of Kieselguhr, two kinds of pores are found, which play different part on hydrophobicity transfer process. It is proposed that there are two patterns superimposed in hydrophobicity transfer process. One was the “fast process”, determined by the large pore among inert material particles, controlled hydrophobicity transfer speed in first 10 hours. While the other was the “slow process”, resulted by the small pore in inert material particles, determines the final static contact angle. In conclusion, the hydrophobicity transfer process from silicone rubber surface to pollutant surface is a superposition effect of the two transfer processes, especially for porous inert materials. This paper has researched the concrete hydrophobicity transfer process considering the influence of non-soluble pollutant microcosmic characteristics. The results have great significance for hydrophobicity transfer theory and guidance value for outdoor insulation practice of transmission line.

Novel Method to Measure Contamination on the Hydrophobic Surface of Insulator

A novel method of detecting contamination state on the hydrophobic surface

Analysis of the Contamination of Insulators Using the Partial Surface Conductivity Method

The comparative study of overall and partial surface conductivity method

Measurement of Contamination Distribution on the Hydrophobic Surface of Insulators by a Partial Surface Conductivity Method

Study on Method and Device Used for Evaluating the Contamination Condition on the Surface of Composite Insulator

A Low-Cost Evaluation and Correction Method for the Soluble Salt Components of the Insulator Contamination Layer

Measurement of Saturated Water Absorption of the Contamination Layer Deposited on Insulator Surface

Study on the Pollution Regularity of Insulator Using Partial Conductivity Method

Natural Contamination Deposition Characteristics Based on Natural Contamination Testing Station

Study On The Pollution Regularity Of Insulator Using

Study on the Polluted Regularity of Insulators Quantitatively Described by Partial Surface Conductivity

Description method II for unobvious hydrophobic state of composite insulators-uncertainty of hydrophobic degree by spray grading method

Influence of Partial Electric Arc on the Contamination Degree Monitoring System in View of Leakage Current

Influence of Non-Soluble Contamination Microscopic Properties on Hydrophobicity Transfer on Silicone Rubber Surface of Composite Insulator

Insulator Contamination Monitoring Based on Its Hygroscopicity Under Unsaturated Humidity

Instruments and Method for Measuring Partial Surface Conductivity

Measurements of Equivalent Salt Deposit Density (ESDD) on a Suspension Insulator

Study on Measurement of Grounding Current and Its Characteristics for Composite Insulator

Description Method Ⅰfor Unobvious Hydrophobic State of Composite Insulators——Usability of Contact Angle Method

Laboratory study on hydrophobicity and pollution flashover properties of polymer insulators