Abstract:How to determine the contamination degree is a hot topic of outdoor insulation. Many researchers overseas and domestic have been exploring the measuring methods of contamination degree of outdoor insulation for a long time, several methods have been found and surface conductivity method is one of them. The measuring condition of overall surface conductivity method is identical with the operation condition of insulators used in real overhead transmission lines, so it is a good method to measure contamination degree and can reflect the real contamination states of outdoor insulation, however it needs high voltage, heave and costly equipment and is seriously affected by the air gap between end fitting and contamination on the insulator. Therefore, a new method - partial surface conductivity method is put forward, it can overcome all the drawbacks of overall surface conductivity method. In addition, The measuring process of partial surface conductivity method is very simple and will not destroy the contamination layers of outdoor insulation and can very easily measure out the distribution of contamination on the surface of insulators, this has great significance to the study of insulator contamination. But now the studies to this method are very few and the relation between overall and partial surface conductivity method is not very clear. This paper has a deep study of the relations between overall and partial surface conductivity method on rectangular glass board, RTV board and triangular glass board. The result is that when the artificial contamination on the sample plates is fully damped, the measuring value of overall and partial surface conductivity method is proximately same.

Instruments and Method for Measuring Partial Surface Conductivity

Measurement of Contamination Distribution on the Hydrophobic Surface of Insulators by a Partial Surface Conductivity Method

Conductivity Measuring System of Unit Surface and Its Application

Research on Partial Equivalent Salt Deposit Density for Insulator

The comparative study of overall and partial surface conductivity method

Novel Method to Measure Contamination on the Hydrophobic Surface of Insulator

A novel method of detecting contamination state on the hydrophobic surface

Online Measurement of Conductivity/permittivity of Fluid by a New Contactless Impedance Sensor.

Research on Analysis Method of Equivalence Between Natural Polluted Insulators and Artificial Contaminated Insulators

A method for measuring surface electric field intensity of insulators based on electroluminescent effect

A Low-Cost Evaluation and Correction Method for the Soluble Salt Components of the Insulator Contamination Layer

Study on the Pollution Regularity of Insulator Using Partial Conductivity Method

Effect of Soluble Salt Composition on Contamination Degree of Insulator Surface

Study on the Polluted Regularity of Insulators Quantitatively Described by Partial Surface Conductivity

Non-contact surface water conductivity measurement system

A Forecast Method for Leakage Current of Contaminated Insulator Under Saturated Moist

Analysis of the Contamination of Insulators Using the Partial Surface Conductivity Method

Influence of Partial Electric Arc on the Contamination Degree Monitoring System in View of Leakage Current

Development and Site Application of Portable Leakage Current Monitoring System

Study On The Pollution Regularity Of Insulator Using

Study on Method and Device Used for Evaluating the Contamination Condition on the Surface of Composite Insulator