Abstract:Pollution accumulation and the wetting of the contamination layer subsequently formed on the insulator surface are two important factors influencing the pollution flashover of the insulators. To investigate the wetting of contamination layer on the insulator surface, the saturated water absorption of contamination layer on glass specimens was measured in a fog room and the experimental results were analyzed. Under saturated moisture condition, there is a fixed ratio of conductive particles to water molecules in the salt fog that is generated by an ultrasonic humidifier. When the salt fog particles were deposited on the specimens, the surface conductivity of the contamination layer will increase linearly with the salt fog mass deposited. In this paper, a new method was proposed to measure the saturated water absorption of the contamination layer based on the surface conductivity. Based on this method, the influence of non-soluble deposit density (NSDD) and the inclination angle of specimen on the saturated water absorption of the contamination layers were analyzed. The experimental results showed that the saturated water absorption of contamination layer gradually decreased with the increase of inclination angle. With the same NSDD, the saturated water absorption of the contamination layer at the bottom surface of the specimen was less than that of the top surface. The increase of NSDD would lead to an increase of saturated water absorption of the contamination layer under vertical arrangement.

Effect of Soluble Salt Composition on Contamination Degree of Insulator Surface

Analysis on Wetting and Conductive Properties of Natural Polluted Insulators

Experimental Study on Streamer Discharge Characteristics Along Contamination Insulator Surface

Effects of Natural Contamination Components on the Surface Conductivity under Saturated Moisture

Effect of Soluble Salt on Conductivity of Partial Surface

Measurement of Contamination Distribution on the Hydrophobic Surface of Insulators by a Partial Surface Conductivity Method

Research on Partial Equivalent Salt Deposit Density for Insulator

Investigation on Wetting Process of Polluted Composite Insulators

A Low-Cost Evaluation and Correction Method for the Soluble Salt Components of the Insulator Contamination Layer

Influence of High Conductivity Fog on the Hydrophobicity of Composite Insulator

Effective Equivalent Salt Deposit Density of Polluted Silicone Rubber Insulators in Wetting Process

A Forecast Method for Leakage Current of Contaminated Insulator Under Saturated Moist

STUDY OF THE POLLUTION PERFORMANCE OF COMPOSITE INSULATOR IN HIGH ALTITUDE AREA

Temporal and spatial characteristics of soluble salt components accreted on the insulator surface

Influence of Fog-haze Parameters on Equivalent Salt Deposit Density of External Insulation

Influence of Voltage Types and Polarity on Contamination of Insulators

Natural Pollution Component for RTV-coated Insulator in Some Substation of Sichuan Province and Its Effect on Flashover Characteristics

Measurement of Saturated Water Absorption of the Contamination Layer Deposited on Insulator Surface

Wetting Characteristics of Artificial Contamination on the Hydrophobic Surface

Effect of Uneven Hydrophobicity on Anti-pollution Flashover Performance of Line Insulators

Effect of Damp Sheath on Abnormal Temperature Rise at End of Composite Insulator