Abstract:Pollution accumulation and the wetting of the contamination layer subsequently formed on the insulator surface are two important factors influencing the pollution flashover of the insulators. To investigate the wetting of contamination layer on the insulator surface, the saturated water absorption of contamination layer on glass specimens was measured in a fog room and the experimental results were analyzed. Under saturated moisture condition, there is a fixed ratio of conductive particles to water molecules in the salt fog that is generated by an ultrasonic humidifier. When the salt fog particles were deposited on the specimens, the surface conductivity of the contamination layer will increase linearly with the salt fog mass deposited. In this paper, a new method was proposed to measure the saturated water absorption of the contamination layer based on the surface conductivity. Based on this method, the influence of non-soluble deposit density (NSDD) and the inclination angle of specimen on the saturated water absorption of the contamination layers were analyzed. The experimental results showed that the saturated water absorption of contamination layer gradually decreased with the increase of inclination angle. With the same NSDD, the saturated water absorption of the contamination layer at the bottom surface of the specimen was less than that of the top surface. The increase of NSDD would lead to an increase of saturated water absorption of the contamination layer under vertical arrangement.

Influence of Fog-haze Parameters on Equivalent Salt Deposit Density of External Insulation

Influence of High Conductivity Fog on the Hydrophobicity of Composite Insulator

Experimental Study on the Contamination Deposition Characteristics of Insulators in a Fog–haze Environment

Characterisation Parameter of Atmospheric Pollutant Concentration for External Insulation

Effect of Soluble Salt Composition on Contamination Degree of Insulator Surface

Research on Partial Equivalent Salt Deposit Density for Insulator

Experimental Study on Streamer Discharge Characteristics Along Contamination Insulator Surface

Research on Pollution Accumulation Characteristics of Insulators During Fog-Haze Days

Analysis on Wetting and Conductive Properties of Natural Polluted Insulators

Study on Poliution Performance of Line Insulators Under High Altitude Area

Measurement of Contamination Distribution on the Hydrophobic Surface of Insulators by a Partial Surface Conductivity Method

Effect of Damp Sheath on Abnormal Temperature Rise at End of Composite Insulator

Effect of Uneven Hydrophobicity on Anti-pollution Flashover Performance of Line Insulators

STUDY OF THE POLLUTION PERFORMANCE OF COMPOSITE INSULATOR IN HIGH ALTITUDE AREA

A Forecast Method for Leakage Current of Contaminated Insulator Under Saturated Moist

Influence of Voltage Types and Polarity on Contamination of Insulators

Measurement of Saturated Water Absorption of the Contamination Layer Deposited on Insulator Surface

Study on the Contamination Character of Suspending Insulator with RTV Coating

Analysis On Flashover Performance Of Polluted Porcelain Insulators In High Conductivity Fog Environment

Mechanism of Erosion Defect of Composite Insulation Jacket for Current Transformer Under Special Contamination Conditions

AC Pollution Flashover Performance of Insulator Strings Partially Treated With Semiconductive RTV Coating