Abstract:Contamination withstand performance of power equipment adopting silicon rubber as external insulation is dominated by its hydrophobicity. To reveal hydrophobicity transfer mechanism of various non-soluble pollutant on silicon rubber surface, several inert materials of similar chemical component were selected, including Kaolin, Kieselguhr, and silicon dioxide microspheres. Static contact angle tests at various transfer times are performed to obtain the hydrophobicity transfer characteristics of various pollutants. Scanning electron microscope (SEM) test and mercury intrusion porosimetry (MIP) of these inert materials are also carried out to observe the topographical microstructure. Results show that the variations between static contact angle and hydrophobicity transfer time perform great distinction depending on the microscopic properties of inert material. According to MIP and SEM analysis of Kieselguhr, two kinds of pores are found, which play different part on hydrophobicity transfer process. It is proposed that there are two patterns superimposed in hydrophobicity transfer process. One was the “fast process”, determined by the large pore among inert material particles, controlled hydrophobicity transfer speed in first 10 hours. While the other was the “slow process”, resulted by the small pore in inert material particles, determines the final static contact angle. In conclusion, the hydrophobicity transfer process from silicone rubber surface to pollutant surface is a superposition effect of the two transfer processes, especially for porous inert materials. This paper has researched the concrete hydrophobicity transfer process considering the influence of non-soluble pollutant microcosmic characteristics. The results have great significance for hydrophobicity transfer theory and guidance value for outdoor insulation practice of transmission line.

Wetting Characteristics of Artificial Contamination on the Hydrophobic Surface

Study of DC Arc Characteristics on Polluted Silicon Rubber Surface

Effective Equivalent Salt Deposit Density of Polluted Silicone Rubber Insulators in Wetting Process

Influence of Non-Soluble Contamination Microscopic Properties on Hydrophobicity Transfer on Silicone Rubber Surface of Composite Insulator

Experimental Study on the Pollution Flashover Mechanism of Polymer Insulators

Flashover Characteristic of Polluted Silicone Rubber with Different Hydrophobicity

Influence of Ambient Humidity on Hydrophobicity Transfer of Silicone Rubber Material

Degradation Progress of Silicon Rubber Surface Properties under DC Contamination Flashover

Wetting Characteristics of the Hydrophobic Material Surface Through Condensation

Surface Discharge Of Silicone Rubber Under Polluted Conditions

Influence of Environmental Factors on Hydrophobicity Transfer Property of Silicone Rubber Material

Measurement of Saturated Water Absorption of the Contamination Layer Deposited on Insulator Surface

Influence of Silicone Rubber Coating on the Characteristics of Surface Streamer Discharge

Impact of Surface Discharge on Pollution Layer of Silicone Rubber Insulator

Research On The Discharge Mechanism Of The Algae-Contaminated Insulators

Influence of Contamination on the Hydrophobic Properties of APPJ-treated Silicone Rubber

The Effect of Powdered Layer on the Physicochemical Properties of Silicone Rubber Surface

Study on Discharge of Silicone Rubber Composite Insulator Surface Attached with Water Droplets Based on Experiment and Electrostatic Field Simulation

Investigation on Hydrophobicity Transfer Property of Silicone Rubber under Heavy Contamination

Characteristics of Charge Dissipation on Super-Hydrophobic Surface of Silicone Rubber and Its Influence on Hydrophobicity

Modeling of the Salt Dissolving Process of Wet Natural Pollution on Silicone Rubber Insulators