Abstract:Contamination withstand performance of power equipment adopting silicon rubber as external insulation is dominated by its hydrophobicity. To reveal hydrophobicity transfer mechanism of various non-soluble pollutant on silicon rubber surface, several inert materials of similar chemical component were selected, including Kaolin, Kieselguhr, and silicon dioxide microspheres. Static contact angle tests at various transfer times are performed to obtain the hydrophobicity transfer characteristics of various pollutants. Scanning electron microscope (SEM) test and mercury intrusion porosimetry (MIP) of these inert materials are also carried out to observe the topographical microstructure. Results show that the variations between static contact angle and hydrophobicity transfer time perform great distinction depending on the microscopic properties of inert material. According to MIP and SEM analysis of Kieselguhr, two kinds of pores are found, which play different part on hydrophobicity transfer process. It is proposed that there are two patterns superimposed in hydrophobicity transfer process. One was the “fast process”, determined by the large pore among inert material particles, controlled hydrophobicity transfer speed in first 10 hours. While the other was the “slow process”, resulted by the small pore in inert material particles, determines the final static contact angle. In conclusion, the hydrophobicity transfer process from silicone rubber surface to pollutant surface is a superposition effect of the two transfer processes, especially for porous inert materials. This paper has researched the concrete hydrophobicity transfer process considering the influence of non-soluble pollutant microcosmic characteristics. The results have great significance for hydrophobicity transfer theory and guidance value for outdoor insulation practice of transmission line.

Impact of Surface Discharge on Pollution Layer of Silicone Rubber Insulator

Study of DC Arc Characteristics on Polluted Silicon Rubber Surface

Fixation of dust layer on composite insulator surface and its effect on insulating properties

Surface Discharge Of Silicone Rubber Under Polluted Conditions

Influence of AC and DC Voltage Superposition on Partial Discharge of Composite Insulator

Influence of Silicone Rubber Coating on the Characteristics of Surface Streamer Discharge

Influence of AC Corona Discharge on Contamination Layer of Composite Insulator Surface

Research On The Discharge Mechanism Of The Algae-Contaminated Insulators

The Effect of Powdered Layer on the Physicochemical Properties of Silicone Rubber Surface

Wetting Characteristics of Artificial Contamination on the Hydrophobic Surface

Surface Potential Decay and DC Surface Flashover Characteristics of DBD Plasma-Treated Silicone Rubber

Influence of Non-Soluble Contamination Microscopic Properties on Hydrophobicity Transfer on Silicone Rubber Surface of Composite Insulator

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

Influence of Pollution on Surface Streamer Discharge

Study On The Pollution Regularity Of Insulator Using

Study on Discharge of Silicone Rubber Composite Insulator Surface Attached with Water Droplets Based on Experiment and Electrostatic Field Simulation

Effect of Temperature and Humidity on the Surface Charge Decay of Silicone Rubber

Natural Pollution Test of Composite and Porcelain Insulators Under AC and DC Stress

Effective Equivalent Salt Deposit Density of Polluted Silicone Rubber Insulators in Wetting Process

Effect of Hydrophobicity on Electric Field Distribution and Discharges along Various Wetted Hydrophobic Surfaces

Experimental Study on the Pollution Flashover Mechanism of Polymer Insulators