Abstract:Amorphous thin-film TiOx prepared via atomic layer deposition (ALD) has been identified as one of the most promising materials for use in transparent passivating contacts in high-efficiency and low-cost crystalline silicon (c-Si) solar cells. As highlighted in this work, the passivation performance of ALD TiOx layers strongly depends on the metal precursor used, with films prepared using TiCl4 recently showing the best results. However, a full understanding of how such films achieve their high level of surface passivation has not yet been demonstrated. This study provides a clear demonstration that a key part of this passivation mechanism is due to chlorine (Cl) accumulation at the Si surface. This mechanism is demonstrated to be quite general in nature by showing how 2 nm of ALD TiOx (TiCl4 + H2O) can be applied as a capping layer for either ZnO or Al2O3 interlayers to dramatically reduce silicon surface recombination. Cl depth profiles obtained using secondary ion mass spectrometry confirm the presence of Cl extending through the depth of the interlayers with a peak at the silicon interface. Remarkably, this diffusion of Cl is observed following low-temperature (75 °C) deposition of the TiOx capping layer, without any subsequent thermal treatment. Contrary to earlier studies that treated residual Cl in ALD films as a general contamination issue, these findings reveal unequivocally that chlorine plays a crucial role in Si surface passivation and can be classed as an effective passivation element, similar to hydrogen in its ability to passivate Si dangling bonds. The outcomes of this research emphasize the importance of residual chlorine in enhancing the passivation of buried interfaces and provide additional motivation for employing metal chloride precursors for silicon surface passivation applications.

Electrochemistry Of Hypochlorite At Silicon In Alkaline Etchants - Applications In Device Fabrication

Influence of formaldehyde on the electrochemistry and chemical etching of silicon in alkaline solutions

Chemical Etching and Anodic Oxidation of (100) Silicon in Alkaline Solution: the Role of Applied Potential

Etching and passivation of silicon in alkaline solution: A coupled chemical/electrochemical system

Floating Low-Temperature Radio-Frequency Plasma Oxidation of Polycrystalline Silicon-Germanium

The influence of oxidizing agents on etching and passivation of silicon in KOH solution

Galvanic Cell Formation: A Review of Approaches to Silicon Etching for Sensor Fabrication

Porous silicon formation and electropolishing

ON MECHANISMS OF OXYGEN INFLUENCE ON GAS-PHASE PARAMETERS AND SILICON REACTIVE-ION ETCHING KINETICS IN HBr + Cl2 + O2 PLASMA

STM-induced desorption and lithographic patterning of Cl-Si(100)-(2x1)

A Practical Galvanic Etch-Stop in KOH Using Sodium Hypochlorite

Galvanic Cell Formation in Silicon/Metal Contacts: The Effect on Silicon Surface Morphology

Anisotropic Etching of Three-Dimensional Shapes in Silicon - the Important Role of Galvanic Interaction

Dramatic Reduction of Silicon Surface Recombination by ALD TiOx Capping Layer from TiCl4 and H2O: The Role of Chlorine

Recent Advances in Electrochemical-Based Silicon Production Technologies with Reduced Carbon Emission

Selective Etching of Silicon in Aqueous KOH

Etching of high aspect ratio features in Si using SF6∕O2∕HBr and SF6∕O2∕Cl2 plasma

I-V characterization study of porous silicon formation by doubled-cell electrochemical etching

Electrodeposition of Silicon in the Low-Temperature LiCl-KCl-CsCl-K2SiF6 Melt Under Direct and Pulse Current

Toward Cost‐Effective Manufacturing of Silicon Solar Cells: Electrodeposition of High‐Quality Si Films in a CaCl2‐based Molten Salt

The Band Model and the Etching Mechanism of Silicon in Aqueous KOH