Abstract:In this work, BaTiO3 powders were synthesized by molten-salt synthesis method using BaCO3, TiO2, and the eutectic salts (NaCl-KCl) as the raw materials. A systematic study indicating the effects of calcination temperature as well as the molar ratio of NaCl to KCl in the mixed salt with respect to BaCO3-TiO2 on the microstructures of BaTiO3 powders is reported. The results showed that all the powders crystallized in a tetragonal perovskite structure, as confirmed by X-ray diffraction pattern and Raman spectra. With increasing the calcination temperature, the morphology of the as-prepared BaTiO3 powders developed from rectangular/spherical aggregates to circular or cubic shapes and the average particle size was also increased from 320 nm to 900 nm. With increasing the molar ratio of BaCO3: TiO2: NaCl: KCl, the average particle size was slightly decreased from 440 nm to 360 nm, and the morphology of the as-synthesized BaTiO3 powders transformed from rectangular and cubic shapes to sphere shapes. The chemical compositions of the as-synthesized BaTiO3 powders obtained from energy dispersive X-ray analysis are in agreement with the nominal ratios. The present results provide a generalized methodology to large-scale synthesize other perovskite transitional metal oxide powders with controllable sizes and shapes. (C) 2016 Elsevier B.V. All rights reserved.

PREPARATION OF TABULAR BaTiO3 POWDER BY TWO-STEP MOLTEN SALT METHOD

Tabular SrTiO3 Synthesized by Two-Step Molten Salt Method

Molten-salt Synthesis of BaTiO3 Powders and Their Atomic-Scale Structural Characterization

Tabular Sr3Ti2O7 Intermediates Synthesized by Molten Salt Method

PREPARATION AND SINTERING PROPERTIES OF BaTi4O9 BY CITRIC ACID GEL METHOD

Preparation and properties of Ba(Sn0.1Ti0.9)O-3 powders by molten salt method

Citric Acid Gel Method Synthesis, Characterization And Dielectric Properties Of Single-Phase Bati4o9

Room-Temperature Synthesis of BaTiO<sub>3</sub>Nanoparticles in Large Batches

Study of the synthetic process of CaBi2Ta2O9 powder by the molten‐salt method

Molten salt synthesis of Bi2SiO5 powders based on uniform experiment

PREPARATION OF NANOSIZED Bi3.25 La0.75 Ti3 O12 POWDER BY COPRECIPITATION METHOD

Synthesis of Bi0.5(Na0.7K0.2Li0.1)0.5TiO3 powders through the molten salt method

Morphological Control of Ba-Ti-O Particles Prepared by Molten Salt Synthesis

ZnTiO_3 Powder Prepared by Molten Salt Methods

Structure and Electrical Properties of BaTiO3 Prepared by Sol–gel Process

The Effect of B2o3-Li2co3 Addition on Sintering Behavior and Dielectric Properties of Ba0.6sr0.4tio3 Ceramics

Synthesis of Pure Bi<sub>12</sub>SiO<sub>20</sub> Powder by Molten Salt Method

Synthesis of Micron‐Scale Platelet BaTiO3

Low-Temperature High-Efficiency Preparation of TiB 2 Micro-Platelets via Boro/Carbothermal Reduction in Microwave Heated Molten Salt.

Synthesis and Characterization of BaTiO3 Nanopowders Via Solvothermal Method

Hydrothermal synthesis of high-purity BaTiO3 powders: control of powder phase and size, sintering density, and dielectric properties