Abstract:Heat recirculation is crucial to sustaining and stabilizing flames in micro-combustion in which a strong thermal coupling between the combustor wall and gas mixture exists through thermal conduction. Filtration combustion, on the other hand, is able to recirculate heat through the solid matrix to the unburned gas mixture, representing a promising potential to further enhance heat recirculation, if applied in micro-combustion. A numerical study on heat recirculation in premixed H2/air filtration combustion in a planar micro-combustor with the channel height of H = 1mm is carried out. Thermal non-equilibrium between the gas mixture and solid matrix is considered in the 2D numerical model. A parametric study is undertaken to examine the effects of key parameters on the two pathways of heat recirculation in the porous micro-combustor, they are, heat conduction in the combustor wall and conduction and radiation through the solid matrix. The porous micro-combustor has the low-velocity extinction limits as low as ∼0.2m/s and the blowout limits in terms of critical equivalence ratios increase with increasing inlet flow velocity. Flame position and wall temperature are greatly influenced by the porosity (ɛ) and solid matrix thermal conductivity (ks) of the porous medium, but interestingly, the flame temperature seems unaffected within the velocity range studied. Upon quantifying the two pathways of heat recirculation, it is found that convective heat exchange between the gas mixture and solid matrix plays the dominant role, while thermal conduction in the combustor wall the secondary role in preheating the gas mixture. The gas-to-solid convection efficiency (ηg-s) increases with the decrease of ɛ or equivalence ratio (Φ), and the increase of ks. In contrast, the gas-to-wall convection efficiency (ηg-w) increases with the increase of ɛ or Φ. Careful selection of the wall material is important to ensure efficient heat recirculation through the combustor wall.

Numerical simulation of preheating fuel gas combustion in micro-scale tube

Effects of Preheating Fuel Gas to Micro-scale Flame

The Impact of Preheating on Stability Limits of Premixed Hydrogen–Air Combustion in a Microcombustor

Numerical Simulation of Micro-Combustion for Different Heat Loss Conditions

Numerical simulation of premixed n-heptane/air combustion in micro tube with internal channel optimization

Numerical Simulation on Combustion Characteristics of Biofuels with Different Calorific Values

Experimental Study and Numerical Analysis of the Scaling Effect on the Flame Stabilization of Propane/air Mixture in the Micro-Scale Porous Combustor

Effects of heat transfer on flame stability limits in a planar micro-combustor partially filled with porous medium

Temperature and Heat-recirculation Distribution in Micro-scale Combustion

Numerical Study of the Premixed Propane/air Flame Characteristics in a Partially Filled Micro Porous Combustor

Numerical Investigation of Premixed Catalytic Combustion of Methane in Micro-Combustor

Improvement of Micro Flame Stability by Increasing Reaction Temperature

Numerical study on heat recirculation in a porous micro-combustor

Experimental Study on Flame Stability and Thermal Performance of an n-Heptane-Fueled Microscale Combustor

Improving micro combustor stability with external heating

Effect of Thermal Property of Materials on Micro-scale Catalytic Combustion for the Micro Combustor

Numerical Study on Methane/air Combustion Characteristics in a Heat-Recirculating Micro Combustor Embedded with Porous Media

Simulation and Heat Loss Study of the Premixed Combustion of H2/Air

Combustion Characteristics and Thermal Enhancement of Premixed Hydrogen/air in Micro Combustor with Pin Fin Arrays

Numerical Study on the Characteristics of Methane Hedging Combustion in a Heat Cycle Porous Media Burner

Study on the Selection for Micro-combustion Simulation Model