Abstract:Non-premixed turbulent combustion at a supercritical pressure is an important physicochemical phenomenon in many propulsion and power-generation systems. In this paper, a modified flamelet-progress-variable model, in which a simple term is proposed to approximately account for the extra turbulent mixing related to large density difference between two fluid streams, has been developed and incorporated into a single-phase general fluid numerical scheme in RANS framework for solving supercritical-pressure turbulent combustion of hydrocarbon fuels. The model was validated and then applied for studying the coaxial injection and turbulent combustion of LOx/methane and the swirling injection and turbulent combustion of LOx/kerosene at various supercritical pressures. Results indicate that for the coaxial injection and combustion of LOx/methane at a mixture ratio of 3, flame length decreases as chamber pressure increases, dictated by the penetration capability of the injected LOx stream. For the swirling injection and combustion of LOx/kerosene at supercritical pressures, flame moves closer to the injector as chamber pressure increases. This phenomenon at a higher pressure is similar to that caused by an increased inlet-flow swirling number. It suggests that increasing chamber pressure may lead to a shorter combustor for the turbulent combustion of LOx and hydrocarbon fuels. (C) 2017 Elsevier Ltd. All rights reserved.

Study on the Selection for Micro-combustion Simulation Model

Numerical Simulation on Combustion Characteristics of Biofuels with Different Calorific Values

Numerical Simulation of Micro-Combustion for Different Heat Loss Conditions

Modeling and Numerical Simulations of Combustor with Centrifugal Fuel Injection for a Micro Engine

Experimental and Numerical Simulation Study of the Microscale Laminar Flow Diffusion Combustion of Liquid Ethanol

Modeling of Supercritical-Pressure Turbulent Combustion of Hydrocarbon Fuels Using A Modified Flamelet-Progress-Variable Approach

Influence of the turbulence model on the numerical predictions of cold turbulent flow in a heavy-duty gas turbine DLN combustor

The Turbulence Models for Numerical Analysis of Liquid Kerosene Supersonic Combustion

Numerical Simulations and Optimization of a Micro Annular Combustor

Numerical simulation of preheating fuel gas combustion in micro-scale tube

Influence numerical analysis of combustion chamber thermal boundary conditions on unsteady combustion characteristics in micro ICE

Numerical Simulation of Microscale Laminar-Flow Diffusion Combustion of Liquid Ethanol

Burning stability analysis of micro-combustion and experimental research of combustion in microscale tube

Numerical And Experimental Study On Soot Accumulation On The Wall Of Falling Fuel Film Micro-Combustor

Numerical Simulation of Influence of High Temperature Air on Flow in Combustion Backfolw Section

Numerical Investigation of Mixture-Fraction-Based Turbulent Combustion Model in Turbulent Diffusion Flames

Numerical Simulation of Micro Swiss-Roll Combustor

Numerical simulation of supersonic H2/air combustion appling modified k-ε turbulence model

Numerical Investigation of Premixed Catalytic Combustion of Methane in Micro-Combustor

The Research Progress of Combustion Characteristics Based on Micro Scale

Study of Micro Burner Liquid Ethanol Laminar Flow Diffusion Combustion under the Influence of Electric Field