Improvement of Micro Flame Stability by Increasing Reaction Temperature

ZHOU Jun-hu,Yang Wang,Weijuan Yang,LIU Jian-zhong,Zhihua Wang,CEN Ke-fa

2010-01-01

Abstract:Micro combustor suffers considerable surface heat loss,causing a decrease in reaction temperature.Low reaction temperature affects flame stability and causes thermal extinction.In this experiment,the combustor is heated from inside by an electrical-heating wire,and the increased reaction temperature leads to less negative effects of heat loss,thus improving the performance of the combustor.The combustor is a straight quartz tube,with a length of 82 mm and a flow area of 3.33 mm2.The H2/air mixture flow rates are 0.12 L/min,0.2 L/min,0.4 L/min,and the heat-ing power is adjusted to 0 W,1.05 W,4.70 W.The experimental result shows that heating helps inhibit extinction.Increasing fuel-mixture flow rate is also in favor of flame stabilization.However,high flow rate induces blow-out.Combined with the measured surface temperatures,the combustion process is investigated through numerical simula-tion.The results show that high heating power increases reaction temperature and OH concentration,thus proving that heating intensifies reaction and inhibits extinction.Surface heat losses under different conditions are compared.With the heating power of 0 W,the flow rates increase from 0.12 L/min to 0.2 L/min,and the ratio of surface heat loss to injected total energy decreases from 84.8% to 81.1%.Therefore,increasing flow rates within a certain scope inhibits extinction.