Enhancement of flame stabilization ability of a miniature tubular combustor by filling T-shaped porous media

Guangyao Yang,Aiwu Fan

DOI: https://doi.org/10.1016/j.joei.2024.101704

IF: 6.47

2024-06-21

Journal of the Energy Institute

Abstract:Porous media combustion is a frequently adopted technology for flame stabilization. However, the solid matrix has a redirection influence on incoming flow, which reduces boundary layer thickness and weakens the flame stabilization ability to some extent. Our previous experimental investigation showed that C 4 H 10 /air flames were suspended above the porous media that filled in a miniature tubular burner (ID = 6 mm). The upper velocity limit (i.e., blow-off limit) turned out to be 0.55 m/s, which was only slightly higher than the laminar burning velocity (∼0.4 m/s). To enhance flame stabilization ability of this combustor, a method of filling a T-shaped porous zone was proposed in this study. Total length of the porous zone is 10 mm while the protruding part length ( L 22 ) is variable. Effect of L 22 ( L 22 = 0, 2, 4, 6, 8 mm) on the blow-off limit of stoichiometric C 4 H 10 /air flames was numerical explored. The blow-off limit increased monotonically with an increasing L 22 , reaching 1.05 m/s at L 22 = 8 mm. Analysis demonstrated that due to a larger flow resistance of the protruding part, a low-velocity zone was formed within it and it was prolonged with the increase of L 22 . Meanwhile, a thicker boundary layer was formed near the wall of annual space. Moreover, heat recirculation through the T-shaped porous zone was intensified compared to the original configuration because the central flame front could be immerged within the protruding part. As a result, flame stabilization capability of the combustor was essentially improved by filling a T-shaped porous media.

energy & fuels