Abstract:The general desulfurization sorbent, limestone is limited in sulfation temperature range and suffers from rapid loss of reactivity and incomplete utilization. However, plentiful shells are generally abandoned as garbage especially in coastal area, which consist of CaCO3 similar to limestone. Desulfurization with shell shows a higher calcium utilization and better sulfation property than limestone under various experimental conditions. The desulfurization reaction process of calcium-based sorbent including four species of shell and a sort of limestone were investigated by thermogravimetric analysis method. The kinetic behavior was expressed by the modified grain model. The activation energy (E-a) and the pre-exponential factor (k(0)) of surface reaction, the activation energy (E-p) and the pre-exponential factor (D-0) of product layer diffusion reaction were calculated and explained according to the model. It is shown that the modified grain model can describe the desulfurization course of shells and limestone. Additions of alkali metal salts may improve microstructure and product diffusion of sorbent during high temperature sulfation, and enhance the initial reaction rate and the final CaO conversion of sorbents. The kinetic parameters of shell desulfurization show a compensation effect. There are linear relationships between logarithms of the pre-exponential factor Ink(0), InD0 and activation energies E-a, E-p respectively. The method based on the isokinetic temperature T. to estimate sorbent activity is applied to different control stage. Alkali metal salts can enhance the initial reaction rate, at the same time can accelerate the high temperature sintering of sorbent, so there is optimal content in sorbent. The advisable molar ratio of alkali metal cations (mainly Na+ and K+) to Ca2+ in the sorbent is best kept to 2% approximately at the desulfurization temperature range of 1 073 -1 273 K.

Desulfurization Characteristic of Calcium-Based Sorbent During Activation Process.

STUDY ON DESULFURIZATION CHARACTERISTIC IN CaO ACTIVATION REACTOR OF LIMESTONE INJECTION FGD SYSTEM Ⅰ--MATHEMATICS MODEL

STUDY ON DESULFURIZATION CHARACTERISTIC IN CaO ACTIVATION REACTOR OF LIMESTONE INJECTION FGD SYSTEM --EXPERIMENTAL RESULTS AND DISCUSSION

Effect of water content on desulfurization characteristic of calcium-based sorbent

Kinetic model for desulfurization at medium temperature using hydrated absorbent

Study on desulfurization reaction characteristic of calcium-based sorbents

Kinetic Model of Cao/Fly Ash Sorbent for Flue Gas Desulphurization at Moderate Temperatures

Sulfation Diffusion Model for SO 2 Capture on the T-T Sorbent at Moderate Temperatures

PORE SIZE DISTRIBUTION MODEL FOR SULFATION OF CALCIUM-BASED SORBENT

A study of experimental and improved absorption model for the spray towers of wet flue gas desulfurization

Cold-modeling Study of a Circulating Fluidized Bed Reactor for Flue Gas Desulfurization (FGD)

Distributed pore-size model for sulfation of calcium-based sorbent

Studies on the Desulfurization Kinetics of Shell Sorbent Using Thermogravimetric Analysis Method

Effect of characteristics of calcium-based sorbents on the sulfation kinetics

Numerical Simulation of Wet Limestone-Gypsum Flue Gas Desulfurization System

Factors Influencing Desulfurization Efficiency of Wet Flue Gas Desulfurization System

Experimental Study of Limestone/Gypsum-based Wet Process Flue Gas Desulfuration

Sorbent Performance under FBC Conditions -- A Thermochemical Analysis

Distributed pore model for sulfation of calcium-based sorbent

Model on desulfurization characteristic of limestone particles

A Model for Flue Gas Desulfurization with Lime Absorbent at Middle Temperature