Abstract:A moderate-temperature desulfurization process at 600-800 degrees C was studied in a pilot-scale circulating fluidized bed flue gas desulfurization (CFB-FGD) experimental facility with the addition of the internal structure. The rapidly hydrated sorbent and the desulfurization products were analyzed to clarify the influence mechanism of the internal structure on the moderate-temperature desulfurization process. The results show that the desulfurization efficiency with the internal structure at 600-800 degrees C was 74-93% for the calcium to sulfur (Ca/S) molar ratio of 2.0, which was higher than the desulfurization efficiency without the internal structure of 67-83%. As for the calcium-containing compositions, the desulfurization products included about 70% cyclone recirculation sample and about 30% bag filter sample. The cyclone recirculation sample was mainly composed of CaSO4 and CaO. The bag filter sample not only contained high contents of CaSO4 and CaO but also contained a considerable amount of CaCO3 and even some unreacted Ca(OH)(2). With the addition of the internal structure, the calcium conversion rate of the cyclone recirculation sample greatly increased from 42.8 to 47.4% while that of the bag filter sample just increased from 29.4 to 30.7%. It demonstrated that the main contributor for the improved desulfurization efficiency was the cyclone recirculation sample clue to the improved solids concentration distribution and the enhanced gas-solid contact efficiency. The calcium conversion rate for the bag filter sample depended on the solids concentration distribution as well as the particle residence time in the moderate temperature range, which indicated that prolonging the particle residence time for the fresh sorbent and the fall off calcium-containing particles was important to further improve the desulfurization performance. These results provided good guidance for realizing high desulfurization efficiency and low flow resistance in dry FGD processes.

Kinetic Model of Cao/Fly Ash Sorbent for Flue Gas Desulphurization at Moderate Temperatures

Kinetic model for desulfurization at medium temperature using hydrated absorbent

Sulfation Diffusion Model for SO 2 Capture on the T-T Sorbent at Moderate Temperatures

Desulfurization Characteristic of Calcium-Based Sorbent During Activation Process.

Comprehensive Sulfation Model Verified for T–T Sorbent Clusters During Flue Gas Desulfurization at Moderate Temperatures

Partially Sulfated Lime-Fly Ash Sorbents Activated by Water or Steam for SO2 Removal at a Medium Temperature

Experimental Study on Abrasion Characteristics of Rapidly Hydrated Sorbent for Moderate Temperature Dry Flue Gas Desulfurization

Experimental and model investigation on the mass balance of a dry circulating fluidized bed for flue gas desulfurization system

COMPARISON OF KINETIC REACTION RATE AND DIFFUSION RATE DURING DRY FGD REACTION WITH CAO PARTICLES

A Model for Flue Gas Desulfurization with Lime Absorbent at Middle Temperature

Experimental study of steam reactivation of calcium-based sorbent for dry FGD process

Experimental Study on in Situ Preparation of Supported Sorbent for Moderate Temperature CFB-FGD

Effect of Internal Structure on Flue Gas Desulfurization with Rapidly Hydrated Sorbent in A Circulating Fluidized Bed at Moderate Temperatures

High Calcium Utilization and Gypsum Formation for Dry Desulfurization Process

Novel Dry-Desulfurization Process Using Ca(OH)2/Fly Ash Sorbent in a Circulating Fluidized Bed

Modeling Of The Aqueous Ca(Oh)(2) Reaction Under Semi-Dry Fgd Condition

INTERACTION BETWEEN SO2 FROM FLUE GAS AND SORBENT PARTICLES IN DRY FGD PROCESSES

Experimental Study On Medium Temperature Dry Flue Gas Desulphurization By Using Active Sorbent In Circulating Fludized Bed

Kinetics of SO2 Adsorption by ZL50 Activated Carbon for Various Water Vapor Volume Fractions

FSI(furnace Sorbent Injection) Desulfurization Modeling

Study on desulfurization reaction characteristic of calcium-based sorbents